Pioneer VSA-AX10 Manuel d'utilisateur télécharger pdf (Page 86)

Advanced Setup

Assigning the Component Video Inputs

If you used component video cords (and only if you did so) to connect any equipment you must tell the

amplifier which device is hooked up with this special kind of cable. If you did not use component video

cord (which is a specialized cord that separates the video signal into two color spectrums and a light

spectrum for transmission) then you don't need to worry about the procedure below. The default settings

for the component video inputs are off.

Turn on the amplifier and your TV,

press the AMP on the remote

control.

Press the SUB button on the remote

control.

Press the SYSTEM SETUP button.

Looking at the on-screen display on

your TV, use the 5∞ buttons to

select INPUT ASSIGN. Press the

ENTER button.

Use the 5∞ buttons to select

COMPONENT VIDEO IN. Press the

ENTER button.

Use the 5∞ buttons to move

through the different component

video input settings and use the

2 3

buttons to select the component

that you hooked up to that

component video in.

If you're not sure which component is connected to

which component video in, look on the back of the

amplifier and check the cables you connected.

When you're finished use the 5∞

buttons to select RETURN and press

ENTER.

You will leave the "Assigning the Component Video

Inputs" mode.

Use the 5∞ buttons to select

RETURN and press ENTER, again.

Then, use the 5∞ buttons to select

EXIT and press ENTER.

STATUS

SPEAKER

A/B

LOUDNESS

INPUT

ATT.

Amplifier

MAIN SUB

SIGNAL

SELECT

TAPE 2

MONITOR

SYSTEM

SETUP

DISPLAY

DIMMER

VIDEO

SELECT

EFFECT/

CH SEL.

BASS/

ATREBLE

TONE

AMP

DVD/LD

VCR1

/DVR

VCR2

VCR3

REMOTE

SETUP

CD-R/

TAPE1

TUNER

VIDEO

SAT

CONTROL

1.Input Assign

[ 1.Digital-In ]

[ 2.Component Video In ]

[ 3.i.LINK Input ]

[Return]

1.2. Component Video In

Component-1 [DVD/LD ]

Component-2 [ OFF ]

Component-3 [ OFF ]

[Return]

memo

System Setup

[ Auto Surround Setup ]

[1. Input Assign ]

[2. Surround Setup]

[3. Expert Setup]

[4. THX Audio Setup]

[Exit]

1.2. Component Video In

Component-1 [DVD/LD ]

Component-2 [ VCR1 ]

Component-3 [ OFF ]

[Return]

If you connect the TV monitor with com-

ponent video cord, and the DVD player

with composite or S video cord then you

should set that terminal to off.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 111 112

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSA-AX10 Manuel d'utilisateur Page 86

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Pioneer VSA-AX10