Pioneer VSA-AX10 Manuel d'utilisateur télécharger pdf (Page 91)

Advanced Setup

EXPERT

Follow steps 1-4 on page 89, if necessary, to get to the

starting point mentioned here.

BASS PEAK LEVEL should be

selected if it isn’t use the 5∞

buttons to select it. Press ENTER.

The present level of the BASS PEAK LEVEL is dis-

played (

When [- - -] is displayed the bass limiter is set to minus

infinity and no bass is output.

When [OFF] is displayed the bass limiter is off and

bass output is not limited at all.

Use the 5∞ buttons to select

SETTING START or SETTING CANCEL.

SETTING START: The MASTER VOLUME is set to

MIN (----dB), a test tone plays back and you make the

setting (in step 3).

SETTING CANCEL: This setting won't limit the peak

level of the LFE channel.

For SETTING START, select it and press ENTER. Then

go on to step 3.

For SETTING CANCEL, select it and press ENTER.

The bass peak level setting is finished. Go on to the

next setup.

Use the 2 3 buttons to adjust the

test tones and specify the bass peak

level.

1 Raise the level gradually.

2 Set the bass peak level at the point just before the

tone starts to distort.

Be careful! Test tones play back at loud volumes .

Make sure there are no infants or small children in

the room at distortion level.

If the YES or PLUS setting on the subwoofer is

selected the test tone will only play back from the

subwoofer. If not, the test tone will play back from all

speakers set to LARGE except for the subwoofer.

Press ENTER.

The display on the amplifier will show RESUME and

the MASTER VOLUME will return to its original

position.

If you want to continue EXPERT

SETUP use the 5∞ buttons to select

the next setup and press ENTER.

Go on to the next page.

If you want to finish EXPERT SETUP use

the 5∞ buttons to select RETURN and

press ENTER. Then use the 5∞ buttons

to select EXIT and press ENTER.

MASTER VOLUME +/–

If you set the THX Ultra2 feature on

p.108 the BASS PEAK LEVEL feature

will be cancelled.

VOL

LINE/

TUNER

CONTROL

MUTING

MASTER VOLUME

–

VOL

–

FUNCTION

memo

3.2. Bass Peak Level

Manager

[Setting Start]

[Setting Cancel]

[Return]

Present Level [OFF]

4.Expert Setup

[1. OSD Adjustment ]

[2. Bass Peak Level ]

[3. D-Range Control ]

[4. Multi-Ch In Select ]

[5. Function Rename ]

[6. Hi-bit/Hi-sampling ]

[Return]

3.2. Bass Peak Level

Manager

[Setting OK]

Bass Peak Level

[–10]

[Setting Cancel]

BASS PEAK LEVEL

The LFE (Low Frequency Effect) channel in Dolby Digital, MPEG or DTS program sources can produce heavily

concentrated ultra-low bass tones that may exceed the capabilities of your speaker system. The following steps

show you how to set the peak level for the ultra-low bass or low frequency effect (LFE) channel. If continuing

from the preceding page the BASS PEAK LEVEL MANAGER should be selected.

ENTER

STANDBY/ON

5˜∞˜2˜3˜ENTER buttons

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 111 112

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSA-AX10 Manuel d'utilisateur Page 91

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Pioneer VSA-AX10