Pioneer VSA-AX10 Manuel d'utilisateur Page 74

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 112
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 73
74
En
Using Other Functions
Switching A/B Speaker System
This unit has three types of speaker systems A, B, A&B. This switch allows you to select the speaker system
you will use.
1
Use the SPEAKER A/B button on the
remote control's SUB screen (or SP
SYSTEM A/B on the front panel) to
cycle through the different speaker
systems.
The button cycles through the speaker systems as
follows: A]B]A&B]off.
In what way the sound will be output depends on
the selections you made in "SPEAKER SYSTEMS"
(p.41) and you choices here. See the explanations
for a guide to how the sound will be output when
you have chosen NORMAL SURROUND (see p.41-
43).
STATUS
SPEAKER
A/B
LOUDNESS
INPUT
ATT.
Amplifier
MAIN SUB
SIGNAL
SELECT
TAPE 2
MONITOR
SYSTEM
SETUP
DISPLAY
DIMMER
VIDEO
SELECT
EFFECT/
CH SEL.
BASS/
TREBLE
TONE
memo
Depending on the settings in "SPEAKER SYSTEMS" and the MULTI CH IN SELECT, output from the
surround back pre out terminals may change.
When using headphones the speakers are switched off.
Please use speakers with a nominal impedance rated 6-16.
1
1
A(SP3A): Sound is output from speaker system A and the same
signal is output from the pre out terminals. (Subwoofer
output depends on the settings in SPEAKER SYSTEMS
and the source type.)
B(SP3B): Sound is output from the two speakers in speaker
system B. Multichannel sources will be downmixed to
these two speakers and the same signal is output from
the FRONT pre outs.
A&B(SP3AB): Sound is output only from speaker system A's FRONT
speakers, a subwoofer and the B speakers. (Subwoofer
output depends on the settings in SPEAKER SYSTEMS
and the source type.) The main channels will be
downmixed to the FRONT speakers. If you have set
the FRONT speakers to "SMALL" the low frequencies
of all the channels are output from the subwoofer. The
same sound as FRONT speakers is output from the B
speakers and the FRONT pre out terminals.
OFF(SP3 ): No sound is output from the speakers. Depending on
the input signal and settings in "SPEAKER SYSTEMS"
sound may be output from the subwoofer. The same
sound is output from the pre out terminals as when
selecting speaker system A (above).
Vue de la page 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 111 112

Commentaires sur ces manuels

Pas de commentaire