Pioneer VSA-AX10 Manuel d'utilisateur télécharger pdf (Page 30)

7 i.LINK connectors

Use a 4-pin, S400 i.LINK cable, less than 3.5 m long,

to connect i.LINK-equipped components.

Be sure to insert the i.LINK cable straight into

connector. When properly aligned the cable can be

inserted with little resistance. Forcing the cable into

the connector will damage the connector pins.

The arrow on the

cable connector body

should be face down

for corrrect alignment

with the connector on

the amplifier.

memo

Using i.LINK Interface

• When properly connected, the i.LINK plug will snap into the connector. If not connected

properly the amplifier will not be able to recognize any connected components.

• After connecting an i.LINK-equipped component to the amplifier, follow the instructions

for both assigning inputs on the amplifier (see p.87) and output settings on the compo-

nent (see the manual that came with the component).

• You can connect several i.LINK-equipped components together in the same way. See

Creating an i.LINK Network below.

• There may be cases where the PQLS/rate control function and/or the i.LINK audio does

not work properly even when connected to an i.LINK-Audio-compatible equipment.

• Do not connect/disconnect i.LINK cables or switch on/off any components connected

using i.LINK while the amplifier is on.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 111 112

Pas de commentaire

Pioneer VSA-AX10 Manuel d'utilisateur Page 30