Pioneer VSA-AX10 Manuel d'utilisateur télécharger pdf (Page 38)

38

En

Displays & Controls

Amplifier SUB Screen

-

STATUS

SPEAKER

A/B

LOUDNESS

INPUT

ATT.

MAIN SUB

SIGNAL

SELECT

TAPE 2

MONITOR

SYSTEM

SETUP

DISPLAY

DIMMER

VIDEO

SELECT

EFFECT/

CH SEL.

BASS/

TREBLE

TONE

1

2

3 0

9

4

5

7

6

8

Amplifier

1 Amplifier SUB button

Press this button to select the SUB amplifier

screen (above) when the remote control is on the

main amplifier screen.

2 DISPLAY DIMMER button (see p.64)

Use to adjust the brightness of the amplifier's

display.

3 STATUS button (see p.65)

Use to display the present mode of the

amplifier and other selected settings.

4 SYSTEM SETUP button

Use for all system setups, including the speaker

and sound systems. For more information see

“Setting up for Surround Sound“ starting on p.40.

5 VIDEO SELECT button

Use to toggle between the different video input

possibilities.

6 SPEAKER A/B button (see p.74)

Use to select the speaker system. A is the

primary setting. The button cycles through the

speaker systems as follows: A]B]A&B]off.

Different conditions apply when bi-amping the

speakers. For this case refer to p.73.

7 LOUDNESS button (see p.59)

Switches the LOUDNESS mode on or off (for all

modes except THX).

8 TAPE 2 MONITOR button

Selects the tape deck (or MD recorder, etc.)

connected to the TAPE 2 MONITOR inputs/

outputs. Allows monitoring of a recording as it's

being made.

9 SIGNAL SELECT button (see p.52)

Use to select the type of signal being input into

the receiver. Depending on your INPUT ASSIGN

settings (see pages 85-88) available inputs will

change. Since there is no indicator light for

i.LINK, when it is selected none of the indica-

tors listed below will light. When none are lit

this indicates i.LINK is selected. Press SIGNAL

SELECT repeatedly to select one of the

following:

ANALOG – To select an analog signal.

DIGITAL – To select an optical or coaxial digital

signal.

nothing lit – To select an i.LINK signal.

2 RF – To select an 2 RF signal.

AUTO – This is the default setting. The

receiver selects a signal based on availability, in

the following order of priority: i.LINK, 2 RF,

DIGITAL, ANALOG.

0 INPUT ATT. button

Use to lower the input level of an analog signal

that is too powerful, thus causing the amplifier to

distort. In this case the overload (OVER) indicator

will be flashing furiously.

- TONE control/EFFECT CH SEL. buttons

TONE button

This button has two functions. Firstly, it

switches between TONE on and TONE BY-

PASS, which bypasses the tone circuitry.

Secondly, you need to press the button before

using the BASS & TREBLE (+/–) buttons (see

p.60).

EFFECT/CH SEL. button

Switches the tone adjust controls between the

front, center, surround and surround back

speakers (see p.44, memo). While in Advanced

mode SOUND DELAY can always be selected,

not only while in Advanced mode, you can also

adjust the effect level (see p.55) or SOUND

DELAY in 5 ms steps from 0 to 200 ms to

match sound with slower video displays (see

p.60).

You can then use the + and – buttons to adjust

the sound.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 111 112

Commentaires sur ces manuels

Pas de commentaire