Pioneer VSA-AX10 Manuel d'utilisateur télécharger pdf (Page 43)

SURROUND SETUP

CHANNEL LEVEL should be selected. If

it isn’t use the 5∞ buttons to select

and press ENTER.

There are three ways to set the

CHANNEL LEVEL: MANUAL; SEMI

AUTO; AUTO. Select a setting mode

with the 5∞ buttons and pressing

ENTER. Test tones will be output.

MANUAL: For this setting method you move the test

tone manually and adjust the channel level.

SEMI AUTO: in this setting the test tone moves by

itself and you set the levels.

AUTO: This way of setting the levels is like that de-

scribed in the Quick Start Guide (p.14-16). The levels are

set automatically by the amplifier as it outputs the test

tones. For this setup you must have the setup mic

connected (see p.14).

WARNING : Be prepared! The test tones are output at

a high volume level.

MASTER VOLUME rotates to the reference position (0 dB).

After a few seconds the test tone is output.

CHANNEL LEVEL (channel balance)

The following steps show you how to balance the sound output level of your speakers. Proper speaker balance

is essential for obtaining high quality surround sound. If continuing from SPEAKER SYSTEMS go to step 1. If

starting fresh, complete steps 1-4 in “Setting Up for Surround Sound“ (p.40) first. If you’re not sure of the best

setting for your system, we recommend using Auto for the CHANNEL LEVEL.

memo

2.2. Channel Level

[Manual]

[Semi Auto]

[Auto]

Normal Surround

[Return]

Your Speaker Systems

” Normal Surround ”

2.Surround Setup

[ Check ]

[ 1.Speaker Systems ]

[ 2.Channel Level ]

[ 3.Speaker Distance ]

[ 4.Acoustic Cal EQ ]

[Return]

5˜∞ buttons

ENTER

STANDBY/

Setting Up for Surround Sound

If your subwoofer has a volume con-

trol, set it to the middle position be-

fore doing these operations.

memo

If you have a subwoofer and like lots of bass, it may seem logical to select LARGE for your front

speakers and PLUS for the subwoofer. This may not, however, yield the best bass results. Depending

on the speaker placement of your room you may actually experience a decrease in the amount of

bass due to what is called "low frequency cancellations". In this case, arrange the position or direction

of speakers. If you can’t get good results, listen to the bass response with it set to PLUS and YES or

the front speakers set to LARGE and SMALL alternatively and let your ears judge which sounds best.

If you have a subwoofer, the easiest option is to route all the bass sounds to it by selecting SMALL

for the front speakers.

2.1. Speaker Systems

Manual Free

” Normal Surround ”

Crossover [ 80Hz ]

Normal Surround

(THX Speaker = 80Hz)

Speaker B : Secound Zone

[Return]

Use the 5∞ buttons to select RETURN

and press ENTER.

Next, proceed to CHANNEL LEVEL below.

If you want to change a setting before proceeding

start over from step 1.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 111 112

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSA-AX10 Manuel d'utilisateur Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Pioneer VSA-AX10