Pioneer VSA-AX10 Manuel d'utilisateur télécharger pdf (Page 93)

Advanced Setup

EXPERT

MULTI CH IN SELECT

Use this feature to adjust the type of output for audio signals which were input from MULTI CH INPUT

terminals. You can set the output of the audio signal in regards to the surround speakers and the surround

back speakers, which were input from 5.1 channel surround sound soundtrack.

There are three OUTPUT MODE settings:

THROUGH: the sound is output directly how it was input.

S =SB: The audio signal which was input into the surround channels will be output from the surround

back speakers only.

S=S & SB: The audio signal which was input into the surround channel is output from the surround

speakers and from the surround back speakers. This setting will give the most realistic home theater

experience in the MULTI CH IN SELECT setting if you don't connect surround back inputs.

Follow steps 1-4 on page 89, if necessary, to get to the

starting point mentioned here.

MULTI-CH IN SELECT should be

selected if it isn’t use the 5∞ buttons

to select it. Press ENTER.

Use the 2 3 buttons to select surround

back input: YESx2 ( ), YESx1 ( ) or

NO ( )

You do this to establish the proper downmixing of sur-

round back channels. If you connected two surround back

inputs choose YESx2. If you connected one surround back

input choose YESx1. And if you connected no surround

back inputs choose NO.

Use the 5∞ buttons to select the

OUTPUT MODE you want.

See the OUTPUT MODE explanations above. For details

on speaker placement in this mode see page 103.

Use the 2 3 buttons to choose a type

of output mode: THROUGH, S =SB,

S=S & SB.

Use the 5∞ buttons to select RETURN.

Press ENTER.

Your MULTI CH IN SELECT output set. Next, move on to

FUNCTION RENAME, if necessary.

If you want to change a setting before proceeding

Start over from step one.

If you want to continue EXPERT SETUP

use the 5∞ buttons to select the next

setup and press ENTER.

Go on to the next page.

If you want to finish EXPERT SETUP

use the 5∞ buttons to select RETURN

and press ENTER. Then use the 5∞

buttons to select EXIT and press

ENTER.

3.4. Multi-Ch In Select

Surround Back Input

[Yesx2]

Output Mode

[Through]

[Return]

3.Expert Setup

[1. OSD Adjustment ]

[2. Bass Peak Level ]

[3. D-Range Control ]

[4. Multi-Ch In Select ]

[5. Function Rename ]

[6. Hi-bit/Hi-sampling ]

[Return]

3.4. Multi-Ch In Select

Surround Back Input

[Yesx2]

Output Mode

[ S SB ]

[Return]

4,5

memo

• If you want to setup either S=SB,

S=S & SB, you need to connect

all 7.1 CH speakers, including the

surround back left and right speak-

ers.

• If you use only one surround back

speaker hook it up to the left sur-

round back speaker terminal.

ENTER

STANDBY/ON

5˜∞˜2˜3˜ENTER buttons

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 111 112

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSA-AX10 Manuel d'utilisateur Page 93

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Pioneer VSA-AX10