Pioneer VSA-AX10 Manuel d'utilisateur télécharger pdf (Page 60)

Basic Operation

Adjusting Bass and Treble (TONE CONTROL)

You can adjust the low (bass) and high (treble) frequencies. The TONE button can also be used to bypass the

tone circuitry.

memo

• The tone control can be adjusted in a range of ±6 dB.

• The tone control cannot be set on in HOME THX, MIDNIGHT or LOUDNESS modes.

• If the amplifier is in DIRECT mode and you press the TONE button, TONE: BYPASS appears in

the display. You will need to press TONE once more to switch the tone control on, canceling the

(MULTI CH IN or STEREO) DIRECT mode.

Press the TONE button on the

remote control's AMP SUB screen or

front panel to put the amplifier in

tone adjust mode.

There are two tone modes TONE: ON and TONE:

BYPASS. The first means the tone functions are active

and also lets you adjust these functions. The second

means the tone controls are being bypassed, and thus

have no effect on the sound.

If TONE: BYPASS appears, press the button again to

get TONE: ON, which is the tone adjust mode.

Press the BASS/TREBLE button

repeatedly to select BASS or

TREBLE.

Use the +/– buttons to adjust the low

or high frequency level.

A few seconds after you finish adjusting the tone the

amplifier will revert to the sound mode it was in at the

beginning of the process.

SUB

STATUS

SPEAKER

A/B

LOUDNESS

INPUT

ATT.

Amplifier

MAIN SUB

SIGNAL

SELECT

TAPE 2

MONITOR

SYSTEM

SETUP

DISPLAY

DIMMER

VIDEO

SELECT

EFFECT/

CH SEL.

BASS/

TREBLE

TONE

memo

Press the EFFECT/CH SEL. button

repeatedly until you see DELAY in

the receiver’s display.

Use the +/– buttons to add or

subtract the amount of delay.

• The amount of delay changes in 5 ms steps from

0 – 200 ms. (The default setting value is 0 ms.)

• When in STEREO DIRECT or MULTI CH IN

DIRECT modes, SOUND DELAY cannot be used.

STATUS

SPEAKER

A/B

LOUDNESS

INPUT

ATT.

Amplifier

MAIN SUB

SIGNAL

SELECT

TAPE 2

MONITOR

SYSTEM

SETUP

DISPLAY

DIMMER

VIDEO

SELECT

EFFECT/

CH SEL.

BASS/

TREBLE

TONE

2 2

Listening with SOUND DELAY

Some video displays have a slight delay in presentation of the video. Using SOUND DELAY you can slow the

presentation of the sound to match the presentation of the video.

The following instructions show you how to adjust the amount of delay.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 111 112

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSA-AX10 Manuel d'utilisateur Page 60

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Pioneer VSA-AX10