Pioneer X-HM32V-S Manuel d'utilisateur Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 280
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
Before you start01
6
En
Chapter 1:
Before you start
What’s in the box
Please confirm that the following accessories are in the box
when you open it.
•Remote control
•Power cord
Video cable (1.5 m)
FM wire antenna
AAA batteries (R03) x 2
Speaker wire x 2
iPhone/iPad stand
Warranty card
Operating instructions (this document)
Loading the batteries in the
remote control
1 Open the rear lid and load the batteries as
illustrated below.
2 Close the rear lid.
CAUTION
When inserting the batteries, make sure not to damage
the springs on the battery’s terminals. This can cause
batteries to leak or over heat.
Do not use any batteries other than the ones specified.
Also, do not use a new battery together with an old one.
When loading the batteries into the remote control, set
them in the proper direction, as indicated by the polarity
marks ( and ).
Do not heat batteries, disassemble them, or throw them
into flames or water.
Batteries may have different voltages, even if they are the
same size and shape. Do not use different types of
batteries together.
To prevent leakage of battery fluid, remove the batteries
if you do not plan to use the remote control for a long
period of time (1 month or more). If the fluid should leak,
wipe it carefully off the inside of the case, then insert new
batteries. If a battery should leak and the fluid should get
on your skin, flush it off with large quantities of water.
When disposing of used batteries, please comply with
governmental regulations or environmental public
institution’s rules that apply in your country/area.
WARNING
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the life or
performance of batteries.
Using the remote control
The remote has a range of about 7 m at an angle of about 30º
from the remote sensor.
Keep in mind the following when using the remote control:
Make sure that there are no obstacles between the
remote and the remote sensor on the unit.
Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the unit’s
remote sensor.
Remote controllers for different devices can interfere
with each other. Avoid using remotes for other
equipment located close to this unit.
Replace the batteries when you notice a fall off in the
operating range of the remote.
INP
UT
30°
7 m
30°
;+09B<;(B(QERRN࣮࣌ࢪ㸰㸮㸯㸲ᖺ㸱᭶㸰㸵᪥ࠉᮌ᭙᪥ࠉ༗ᚋ㸱᫬㸲㸶ศ
Vue de la page 5
1 2 3 4 5 6 7 8 9 10 11 ... 279 280

Commentaires sur ces manuels

Pas de commentaire