Pioneer S-81C-QL Manuel d'utilisateur télécharger pdf (Page 4)

When using the non-skid pads

To assure stable installation, affix the non-skid pads to the bottom

surface of the speaker base.

Attaching/removing the grille

This speaker system comes with grille which may be attached and

removed by:

1 To attach the grille, align the grille with the speaker body

and press gently.

2 To remove the grille, hold the grille with both hands near

the middle and pull gently toward you to separate the grille

from the speaker.

• Magnets are used for holding the grille in place. Do not place

the grilles near devices that may be susceptible to magnetic

influence (CRT televisions, etc.).

Connections

This speaker does not include speaker cables used for connecting

to an amplifier.

Connecting the cables

1 Switch off the power to your amplifier.

2 Connect the speaker cables to the input terminals on the

back of the speaker. For input terminal polarity, red is

positive (+) and black is negative (–).

Loosen the knobs on the input terminals and insert the speaker

cable wires into each of the terminal post holes, then tighten the

knobs.

3 Connect the other ends of the cables to the amp's

speaker

output terminals (for more details, refer to your amp

instruction manual).

• You can also connect the speaker’s terminals with a banana

plug. When using a banana plug, be sure to remove the cap at

the tip of the input terminal.

• After connecting the plugs, pull lightly on the cables to make

sure that the ends of the cables are securely connected to the

terminals. Poor connections can create noise and

interruptions in the sound.

• If the cables’ wires happen to be pushed out of the terminals,

allowing the wires to come into contact with each other, it

places an excessive additional load on the amp. This may

cause the amp to stop functioning, and may even damage the

amp.

• When using a set of speakers connected to an amplifier, you

won’t be able to obtain the normal stereo effect if the polarity

(+, –) of one of the speakers (left or right) is reversed.

Speaker base bottom

SPEAKERS

OUTPUT

CENTER

Amplifier (rear)

Speaker (rear):

Input panel

Red

terminal

(+)

Black

terminal

(−)

Red terminal

(+)

Black terminal

(−)

CAUTION

hese speaker terminals carry HAZARDOUS LIVE

voltage. To prevent the risk of electric shock when

connecting or disconnecting the speaker cables,

disconnect the power cord before touching any

uninsulated parts.

D3-4-2-2-3_A_En

FRRD-233-A_S-81C_En.book 4 ページ２００８年７月２２日　火曜日　午後２時２３分

1 2 3 4 5 6 7 8 9 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Pioneer S-81C-QL Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer S-81C-QL