Pioneer MILESTONE 12 Manuel d'utilisateur télécharger pdf (Page 71)

Wall Mount Unit: PDK-WM03

3) Installing the Plasma Display

With the display metal fitting already attached to the Plasma Display, attach the plasma display to the hung on wall unit.

Top hook

Bottom hook

1 Hang the top hooks of the left and right display metal

fittings on the groove in the hung on wall unit.

2 With the top hooks in the groove, lift the

Plasma Display straight up for about 1 cm,

and when you cannot raise it any further,

push the bottom edge of the Plasma

Display to the wall and hang it with the

bottom hooks.

Note

If the bottom of the Plasma Display does not move

when you try to pull it towards you, it is correctly

installed.

Anchor

screw

2 Tighten the anchor screws on the top of the left

and right display metal fitting with a driver.

Note

To install it at a high location where you cannot lift

it manually, you can install it by suspending the

eyebolts on the top hardware of the display with a

crane etc.. When doing this, make sure that the

eyebolt is not loose.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 214 215

Pas de commentaire

Pioneer MILESTONE 12 Manuel d'utilisateur Page 71