Pioneer XC-HM70-K Manuel d'utilisateur télécharger pdf (Page 11)

General control

English Français Español Italiano

Nederlands

Deutsch

General control

To turn the power on

Press the STANDBY/ON button to turn the power on.

After use:

Press the STANDBY/ON button to enter the power stand-by

mode.

Note

•However, if iPod/iPhone is docked, the unit turns charge

mode. “iPod charge” will be displayed.

•During iPod charge mode, press the STANDBY/ON

button to turn the power on.

• Remove iPod to turn the power stand-by mode.

Setting the clock

In this example, the clock is set for the 24-hour (00:00)

display.

1 Press TIMER button on the remote control.

The current date and time are displayed.

The first time you use the clock, you are taken to the clock

adjust mode.

2 Press ENTER button.

3Use

/

to set the day, then press ENTER.

4Use

/

to select 24-hour or 12-hour display, then

press ENTER.

5Use

/

to set the hour, then press ENTER.

6Use

/

to set the minute, then press ENTER to

confirm.

To confirm the time display:

Press the TIMER button. The time display will appear for

about 10 seconds.

Note

• When power supply is restored after unit is plugged in

again or after a power failure, reset the clock (See below).

To readjust the clock:

Perform “Setting the clock” from step 1. If the “Clock” does

not appear in step 2, step 4 (for selecting the 24-hour or 12-

hour display) will be skipped.

To change the 24-hour or 12-hour display:

1 Clear all the programmed contents.

Refer to Factory reset, clearing all memory on page 29 for

details.

2 Perform “Setting the clock” from step 1 onwards.

Display brightness control

Press DIMMER button to dims the display brightness. The

brightness can be controlled in four steps.

Volume auto fade-in

If you turn off and on the main unit with the volume set to 41

or higher, the volume starts at 40 and fades in to the last set

level.

Volume control

Turn the volume knob towards VOLUME (on main unit) or

press VOLUME +/- (on remote control) to increase or

decrease the volume.

CAUTION

• The sound level at a given volume setting depends on

speaker efficiency, location, and various other factors. It

is advisable to avoid exposure to high volume levels. Do

not turn the volume on to full at switch on. Listen to music

at moderate levels. Excessive sound pressure from

earphones and headphones can cause hearing loss.

Auto power down setup

Set to automatically turn off the receiver after a specified time

has passed (when the power has been on with no operation

for several hours).

• Default setting: 6H

1 Press SETUP on the remote control.

•If APD does not appear, press / to select APD.

2Use

/

to specify the amount of time to allow before

the power is turned off (when there has been no

operation).

• You can select 2, 4 or 6 hours, or off (if no automatic

shutoff is desired).

3 When you’re finished, press RETURN.

The 24-hour display will appear.

(00:00 - 23:59)

The 12-hour display will appear.

(AM 00:00 - PM 11:59)

X-HM70_En.book 11 ページ２０１１年７月１１日　月曜日　午前９時２３分

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 223 224

Commentaires sur ces manuels

Pas de commentaire

Pioneer XC-HM70-K Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer XC-HM70-K