Pioneer PDK-1015 Manuel d'utilisateur télécharger pdf (Page 6)

12 mm to 15 mm

(1/2 inch to 5/8 inch)

Using a wall for stabilization

1 Attaching falling prevention bolts (hooks)

to the Plasma Display.

2 Using strong cords to stabilize it

appropriately and firmly to a wall, pillar, or

other sturdy element.

Perform this work in the same way on the left and right

sides.

Note

Use hooks, cords, and fittings that are

available on the market.

Recommended hook:

Nominal diameter M8

Length 12 mm to 15 mm (1/2 inch to

5/8 inch)

Stabilizing on TV table or other location

Stabilize the equipment as shown in the diagram using

screws that are available on the market.

Note

 A TV table with adequate strength, width and depth

should always be used to support the Plasma Display.

Failure to do so could result in falling over.

 To stabilize the Plasma Display on a TV table, use screws

that have a nominal diameter of 6 mm (1/4 inch).

Select the appropriate screws after consulting a profes-

sional installer if necessary.

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.

 Position of table screws

When stabilizing the stand to a TV table, use nominal

diameter 6 mm (1/4 inch) with a length above

20 mm (13/16 inch).

Unit: mm (inch)

Preventing Equipment from Falling Over

• A table or an area of the floor with adequate strength

should always be used to support the Plasma Display.

Failure to do so could result in personal injury and

physical damage.

• When installing the Plasma Display, please take the

necessary safety measures to prevent it from falling or

overturning in case of emergencies, such as

earthquakes, or of accidents.

• If you do not take these precautions, the Plasma

Display could fall down and cause injury.

• The screws, hooks, chains and other fittings that you

use to secure the Plasma Display to prevent it from

overturning will vary according to the composition and

thickness of the surface to which it will be attached.

• Select the appropriate screws, hooks, chains and other

fittings after first inspecting the surface carefully to

determine its thickness and composition and after

consulting a professional installer if necessary.

Min. 20 mm

(13/16 inch)

6 mm

(1/4 inch)

9 mm to 15 mm

(3/8 to 5/8 inch)

Caution

95 (3-3/4)

300

(11-13/16)

585

(23-1/32)

375 (14-3/4)

4.2 (5/32)

Side View

 Because of the Plasma Display’s weight, if it could fall down, this can result in injury.

 For safety, be sure to take special care to ensure that the Plasma Display will not fall over.

1 Hook

2 Cord

Fitting

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Pioneer PDK-1015 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer PDK-1015