Pioneer Super Tuner IIID DEH-P5950IB Manuel d'utilisateur télécharger pdf (Page 21)

Black plate (21,1)

3 Press a or b to set the date and clock.

Pressing a will increase the value of the se-

lected segment. Pressing b will decrease the

value of the selected segment.

Setting the FM tuning step

The FM tuning step employed by seek tuning

can be switched between 100 kHz, the preset

step, and 50 kHz.

1 Press FUNCTION to select FM STEP.

2 Press c or d to select the FM tuning

step.

Press c to select 50 (50 kHz). Press d to se-

lect 100 (100 kHz).

Note

If seek tuning is performed in 50 kHz steps, sta-

tions may be tuned in imprecisely. Tune in the sta-

tions with manual tuning or use seek tuning

again.

Setting the AM tuning step

The AM tuning step can be switched between

9 kHz, the preset step, and 10 kHz. When

using the tuner in North, Central or South

America, reset the tuning step from 9 kHz (531

kHz to 1 602 kHz allowable) to 10 kHz (530 kHz

to 1 640 kHz allowable).

1 Press FUNCTION to select AM STEP.

2 Press c or d to select the AM tuning

step.

Press c to select 9 (9 kHz). Press d to select

10 (10 kHz).

Switching the warning tone

If the front panel is not detached from the

head unit within five seconds of turning off the

ignition, a warning tone will sound. You can

turn off the warning tone.

1 Press FUNCTION to select

WARNING TONE.

2 Press a or b to turn WARNING TONE

on or off.

Switching the auxiliary setting

Auxiliary equipments connected to this unit

can be activated individually. Set each AUX

source to ON when using. About connecting

or using auxiliary equipments, refer to Using

the AUX source on page 23.

1 Press FUNCTION to select AUX1/AUX2.

2 Press a or b to turn AUX1/AUX2 on or

off.

Switching the dimmer setting

To prevent the display from being too bright at

night, the display is automatically dimmed

when the car’s headlights are turned on. You

can turn the dimmer on or off.

1 Press FUNCTION to select DIMMER.

2 Press a or b to turn DIMMER on or off.

Setting the rear output and

subwoofer controller

This unit’s rear output (rear speaker leads out-

put and RCA rear output) can be used for full-

range speaker (REAR SP FULL) or subwoofer

(REAR SP S/W) connection. If you switch the

rear output setting to REAR SP S/W, you can

connect a rear speaker lead directly to a sub-

woofer without using an auxiliary amp.

1 Press FUNCTION to select

S/W CONTROL.

<XRD7120-A/N>21

Operating this unit

En

21

English

Section

02

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 111 112

Commentaires sur ces manuels

Pas de commentaire