Pioneer SUPER TUNER III D FH-P8000BT Manuel d'utilisateur télécharger pdf (Page 49)

Note

You can match the clock to a time signal by

pressing MULTI-CONTROL.

! If 00 to 29, the minutes are rounded down.

(e.g., 10:18 becomes 10:00.)

! If 30 to 59, the minutes are rounded up. (e.g.,

10:36 becomes 11:00.)

Switching the auxiliary setting

Auxiliary devices connected to this unit can be

activated individually. Set each AUX source to

ON when using. For more information about

connecting or using auxiliary devices, refer to

Using the AUX source on page 53.

1 Display the initial setting menu.

Refer to Adjusting initial settings on the pre-

vious page.

2 Use MULTI-CONTROL to select AUX1/

AUX2.

3 Press MULTI-CONTROL to turn AUX1/

AUX2 on.

# To turn AUX off, press MULTI-CONTROL

again.

Switching the dimmer setting

To prevent the display from being too bright at

night, the display is automatically dimmed

when the car’s headlights are turned on. You

can turn the dimmer on or off.

1 Display the initial setting menu.

Refer to Adjusting initial settings on the pre-

vious page.

2 Use MULTI-CONTROL to select DIMMER.

3 Press MULTI-CONTROL to turn dimmer

on.

# To turn dimmer off, press MULTI-CONTROL

again.

Setting the rear output and

subwoofer controller

This unit’s rear output (rear speaker leads out-

put and RCA rear output) can be used for full-

range speaker (REAR SP :FULL) or subwoofer

(REAR SP :S/W ) connection. If you switch the

rear output setting to REAR SP :S/W, you can

connect a rear speaker lead directly to a sub-

woofer without using an auxiliary amp.

Initially, the unit is set for rear full-range speak-

er connection (REAR SP :FULL).

1 Display the initial setting menu.

Refer to Adjusting initial settings on the pre-

vious page.

2 Use MULTI-CONTROL to select

S/W CONTROL.

3 Press MULTI-CONTROL to switch the

rear output setting.

Pressing MULTI-CONTROL will switch be-

tween REAR SP :FULL (full-range speaker) and

REAR SP :S/W (subwoofer) and that status will

be displayed.

# When no subwoofer is connected to the rear

output, select REAR SP :FULL (full-range speak-

er).

# When a subwoofer is connected to the rear

output, select REAR SP :S/W (subwoofer).

Notes

! Even if you change this setting, there is no

output unless you turn the subwoofer output

on (refer to Using subwoofer output on page

46).

! If you change this setting, subwoofer output

in the audio menu return to the factory set-

tings.

! Both rear speaker lead outputs and RCA rear

output are switched simultaneously in this

setting.

Initial Settings

En

49

Section

04

Initial Settings

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 79 80

Commentaires sur ces manuels

Pas de commentaire