Pioneer SUPER TUNER III D FH-P8000BT Manuel d'utilisateur télécharger pdf (Page 51)

Entering PIN code for

Bluetooth wireless connection

To connect your cellular phone to this unit via

Bluetooth wireless technology, you need to

enter PIN code on your phone to verify the

connection. The default code is 0000, but you

can change this in this function.

! With some Bluetooth audio players, you

may be required to enter the Bluetooth

audio player PIN code in advance to set

this unit for a connection.

1 Display the initial setting menu.

Refer to Adjusting initial settings on page 48.

2 Use MULTI-CONTROL to select

PIN CODE INPUT.

3 Push MULTI-CONTROL up or down to

select a number.

4 Push MULTI-CONTROL left or right to

move the cursor to the previous or next po-

sition.

5 After inputting PIN code (up to 16 di-

gits), press MULTI-CONTROL.

PIN code can be stored in memory.

When you press MULTI-CONTROL again on

the same display, the PIN code you entered is

stored in this unit.

# Pushing MULTI-CONTROL right in the confir-

mation display returns you to the PIN code input

display, and you can change the PIN code.

# If an invalid character has been entered in the

beginning, PIN code cannot be stored in mem-

ory.

Editing device name

You can edit the device name.

The device name is set to PIONEER W-DIN BT

as default.

1 Display the initial setting menu.

Refer to Adjusting initial settings on page 48.

2 Use MULTI-CONTROL to select

EDIT DEVICE NAME.

3 Press DISP to select the desired charac-

ter type.

Press DISP repeatedly to switch between the

following character types:

Alphabet—Numbers

4 Push MULTI-CONTROL up or down to

select a letter of the alphabet.

5 Push MULTI-CONTROL left or right to

move the cursor to the previous or next

character position.

6 Move the cursor to the last position by

pushing MULTI-CONTROL right after enter-

ing the device name.

Push MULTI-CONTROL right again to store

the device name in memory temporarily.

# Pressing MULTI-CONTROL can also store the

device name in memory temporarily. In this meth-

od, cursor doesn’t need to be the last position.

# If an invalid character has been entered, sub-

sequent characters are not displayed.

# If an invalid character has been entered in the

beginning, device name cannot be stored in

memory.

Displaying system version

for repair

Should this unit fails to operate properly and

you consult your dealer for repair, you may be

asked to indicate the system versions of this

unit and of Bluetooth module. You can display

the versions and confirm them.

1 Display the initial setting menu.

Refer to Adjusting initial settings on page 48.

2 Use MULTI-CONTROL to select

BT VERSION INFO.

The system (microprocessor) version of this

unit is displayed.

Initial Settings

En

51

Section

04

Initial Settings

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 79 80

Commentaires sur ces manuels

Pas de commentaire