Pioneer AVIC-F940BT Manuel d'utilisateur télécharger pdf (Page 26)

When installing the aerial inside the vehicle (on the dashboard or

rear shelf)

WARNING

Do not install the GPS aerial over any sen-

sors or vents on the dashboard of the vehicle,

as doing so may interfere with the proper

functioning of such sensors or vents and may

compromise the ability of the metal sheet

under the GPS aerial to properly and se-

curely affix to the dashboard.

Affix the metal sheet on the surface as level as

possible where the GPS aerial faces the win-

dow. Place the GPS aerial on the metal sheet.

(The GPS aerial is fastened with its magnet.)

The metal sheet contains a

strong adhesive which may

leave a mark on the surface if

it is removed.

Note

Clamps

Use separately sold clamps

to secure the lead where necessary

inside the vehicle.

GPS aerial

Metal sheet

Peel off the protective sheet

on the rear.

Make sure the surface is

free of moisture, dust,

grime, oil, etc., before

affixing the metal sheet.

Notes

! When attaching the metal sheet, do not cut

it into small pieces.

! Some models use window glass that does

not allow signals from GPS satellites to

pass through. On such models, install the

GPS aerial on the outside of the vehicle.

Engb

Section

Installation

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Pas de commentaire

Pioneer AVIC-F940BT Manuel d'utilisateur Page 26