Pioneer SC-LX82 Manuel d'utilisateur Page 126
- Page / 148
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
The system and the other setup
12
126
En
ZONE Audio Setup
If you’ve made MULTI-ZONE connections (see Using the
MULTI-ZONE controls on page 88), you may need to
specify your volume setting.
1 Select ‘
ZONE Audio Setup
’ from the
Other Setup
menu.
2 Select the volume level setting of
ZONE 2
1
and
ZONE 3
.
• Variable – Use this setting if you’ve connected a
power amplifier in the sub room (this receiver is
simply being used as a pre-amp) and you will be
using this receiver’s controls to adjust the volume.
• Fixed – Use this setting if you’ve connected a fully
integrated amplifier (such as another Pioneer VSX
receiver) in the sub room and want to use that
receiver’s volume controls.
With the Fixed setting, the source is sent from this
receiver at maximum volume, so make sure the volume is
quite low in the sub zone at first, and then experiment to
find the correct level.
3 When you’re finished, press
RETURN
.
You will return to the Other Setup menu.
Power ON Level Setup
The volume can be set so that it is always set to the same
level when the receiver’s power is turned on.
1 Select ‘
Power ON Level Setup
’ from the
Other
Setup
menu.
2 Select the
Power ON Level
setting you want.
• LAST – When the power is turned on, the volume is
set to the same level as when the power was last
turned off.
•“---” – When the power is turned on, the volume is set
to minimum level.
• –80.0dB to +12.0dB – Specify the volume to be set
when the power is turned, in steps of 0.5 dB.
It is not possible to set a volume level greater than the
value specified at Volume Limit Setup.
3 When you’re finished, press
RETURN
.
You will return to the Other Setup menu.
Volume Limit Setup
Use this function to limit the maximum volume. The
volume cannot be increased above the level set here,
even by operating MASTER VOLUME button (or the dial
on the front panel).
1 Select ‘
Volume Limit Setup
’ from the
Other Setup
menu.
2 Select the Volume Limit setting you want.
• OFF – The maximum volume is not limited.
• –20.0dB/–10.0dB/0.0dB – The maximum volume is
limited to the value set here.
3 When you’re finished, press
RETURN
.
You will return to the Other Setup menu.
Note
1 If you selected ZONE 2 in the Surround back speaker setting on page 121, you won’t be able to change the volume level.
2. Multi Ch In Setup
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6.
Remote Control Mode Setup
7.
Flicker Reduction Setup
1. KURO LINK Setup
4d.Other Setup
A/V RECEIVER
Exit Return
4d3.ZONE Audio Setup
A/V RECEIVER
Exit Finish
ZONE 2 Volume Level : Variable
ZONE 3 Volume Level : Variable
4d.Other Setup
A/V RECEIVER
Exit Return
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6.
Remote Control Mode Setup
7.
Flicker Reduction Setup
2. Multi Ch In Setup
1. KURO LINK Setup
4d4.Power ON Level Setup
A/V RECEIVER
Exit Finish
Power ON Level : LAST
4d.Other Setup
A/V RECEIVER
Exit Return
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6.
Remote Control Mode Setup
7.
Flicker Reduction Setup
2. Multi Ch In Setup
1. KURO LINK Setup
4d5.Volume Limit Setup
A/V RECEIVER
Exit Finish
Volume Limit : OFF
SC-LX82_LX72.book Page 126 Thursday, April 23, 2009 7:05 PM
- Operating Instructions 1
- IMPORTANT 2
- VENTILATION CAUTION 3
- Contents 4
- 11 The Advanced MCACC menu 6
- 13 Additional information 6
- Checking what’s in the box 9
- Before you start 10
- Installing the receiver 10
- Loading the batteries 10
- Controls and displays 11
- Front panel 16
- Connecting your equipment 19
- Placing the speakers 22
- Connecting the speakers 23
- About the 26
- audio connection 26
- About the video converter 27
- CAUTION: 33
- ATTENTION: 33
- Connecting AM/FM antennas 35
- FM UNBAL 75 AM LOOP 36
- MULTI-ZONE setup 37
- Connecting an IR receiver 39
- Connecting an HDMI-equipped 41
- Connecting an iPod 42
- Connecting a USB device 42
- Plugging in the receiver 43
- Basic Setup 44
- Control) 45
- The Input Setup menu 47
- Basic playback 49
- Playing an iPod 50
- Playing a USB device 52
- Listening to the radio 55
- Listening to your system 58
- Listening in surround sound 59
- Listening in stereo 61
- Using Stream Direct 62
- Using surround back channel 63
- Setting the Up Mix function 64
- Selecting MCACC presets 64
- Choosing the input signal 65
- Full Band Phase Control 65
- LAN interface 69
- Introduction 69
- About network playback 70
- Server Name 71
- About the playback screen 72
- About Internet radio 72
- Internet Radio 73
- Get access code 73
- About Neural Music Direct 74
- About the Favorites folder 74
- About playable file formats 75
- Setting up the network 76
- Checking the network settings 78
- Software update 78
- Glossary 79
- Windows Media 80
- Windows Media DRM 80
- Windows Media Player 11/ 80
- Windows Media Connect 80
- KURO LINK 81
- KURO LINK Setup 82
- Setting the PQLS function 83
- Synchronized amp mode 84
- Before using synchronization 84
- Using other functions 85
- Setting the Video options 87
- Switching the speaker system 88
- Using the MULTI-ZONE controls 88
- Using the sleep timer 90
- Dimming the display 90
- Switching the HDMI output 91
- Checking your system settings 91
- Resetting the system 92
- (In case of SC-LX82) 93
- AUTO/ALC/ 94
- Direct function 96
- Using System off 97
- Controls for the components 98
- (In case of SC-LX72) 100
- ADV SURR 101
- Programming a multi-operation 102
- Using multi operations 102
- Controls the components 103
- The Advanced MCACC menu 106
- Automatic MCACC (Expert) 107
- Manual MCACC setup 109
- M1.MEMORY1 111
- Checking MCACC Data 115
- Data Management 118
- Chapter 12: 120
- System Setup menu 120
- Manual speaker setup 121
- Channel Level 122
- Speaker Distance 123
- THX Audio Setting 124
- The Other Setup menu 125
- ZONE Audio Setup 126
- Power ON Level Setup 126
- Volume Limit Setup 126
- Remote Control Mode Setup 127
- Flicker Reduction Setup 127
- Additional information 128
- Troubleshooting 129
- Surround sound formats 139
- About iPod 140
- About THX 141
- About Neural – THX Surround 143
- About FLAC 143
- Specifications 145
- Cleaning the unit 145
- PIONEER CORPORATION 148
Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer SC-LX82
(52 pages)
(338 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.077 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels