Pioneer PDP-S39 Manuel d'utilisateur télécharger pdf (Page 4)

English

5 Fix the speaker to the mounting

fittings.

Use the supplied screws to fix the speaker to the

mounting fittings as shown below (3 locations).

NOTE:

Do not use the screw hole located on the underside of the

mounting fittings to fix the speaker.

When using the hung on wall unit :

First install the Plasma Display on the wall with only the

speaker mounting fittings and speaker cable attached to the

display, and then attach the speaker.

1Connect the speaker cable to the speaker terminal.

This illustration shows the PDK-TS12 table top stand.

2Place the speaker on the speaker mounting fittings

and then tighten from below using the screws provided

(3 locations).

CAUTION

If you want to move the Plasma Display unit, make sure

that you remove the speaker first.

In addition, do not move the display holding on to the

mounting fittings. This can result in injury or damage to

the unit.

SRD1303A_01-07/En 6/16/05, 7:04 PM4

1 2 3 4 5 6 7 8 9 ... 37 38

Pas de commentaire

Pioneer PDP-S39 Manuel d'utilisateur Page 4