Pioneer FH-P6200 Manuel d'utilisateur télécharger pdf (Page 30)

1 Press AUDIO to select the slope setting.

Press AUDIO until SLP appears in the display.

# When the subwoofer output is on, you can se-

lect SLP.

2 Press c or d to select slope.

Press c and 12dB is displayed. Press d and

18dB is displayed.

Note

When slope of subwoofer and high pass filter are

12dB, and same cut-off frequency, the phase is

reversed 180 degrees at the cut-off frequency. In

this case, reversing the phase assures improved

sound continuity.

Using the high pass filter

When you do not want low sounds from the

subwoofer output frequency range to play

from the front or rear speakers, turn the HPF

(high pass filter) on. Only frequencies higher

than those in the selected range are output

from the front or rear speakers. You can set up

front and rear separately.

1 Press AUDIO to select F-HPF or R-HPF.

Press AUDIO until F-HPF or R-HPF appears in

the display.

2 Press a to turn high pass filter on.

F-HPF 80Hz or R-HPF 80Hz appears in the dis-

play. High pass filter is now on.

# To turn high pass filter off, press b.

3 Press c or d to select cut-off frequency.

Each press of c or d selects cut-off frequen-

cies in the following order:

506380100125 (Hz)

Only frequencies higher than those in the se-

lected range are output from the front or rear

speakers.

Adjusting high pass filter

attenuation slope

When the high pass filter is on, you can adjust

the continuity of sound between speaker

units.

1 Press AUDIO to select the slope setting.

Press AUDIO until F-SLP or R-SLP appears in

the display.

2 Press c or d to select slope.

Press c and 12dB is displayed. Press d and

6dB is displayed.

Using non fading output

When the non fading output setting is on, the

audio signal does not pass through this units

low pass filter (for the subwoofer), but is out-

put through the RCA output. For more details,

see Switching the RCA output setting on page

37.

1 Press AUDIO to select NonFAD.

Press AUDIO until NonFAD appears in the

display.

# When the RCA output setting is RCA :NON,

you can select NonFAD.

2 Press a to turn non fading output on.

NonFAD :ON appears in the display. Non fad-

ing output is now on.

# To turn non fading output off, press b.

Adjusting non fading output level

When the non fading output is on, you can ad-

just the level of non fading output.

Audio Adjustments

En

30

Section

08

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Commentaires sur ces manuels

Pas de commentaire