Pioneer AVIC-70D-2 Manuel d'utilisateur télécharger pdf (Page 20)

Installation

Installing the GPS aerial

CAUTION

• Do not cut the GPS aerial lead to shorten it or use an extension to make it

longer. Altering the aerial cable could result in a short circuit.

Installation notes

• When installing the GPS aerial inside the vehicle, be sure to use the metal sheet provid-

ed with your system. If this is not used, the reception sensitivity will be poor.

• Do not cut the accessory metal sheet. This would reduce the sensitivity of the GPS aeri-

al.

• Take care not to pull the aerial lead when removing the GPS aerial. The magnet attached

to the aerial is very powerful, and the lead may become detached.

• The GPS aerial is installed with a magnet. When installing the GPS aerial, be careful

not to scratch the vehicle body.

• When installing the GPS aerial on the outside of the vehicle, always put it in the vehicle

when going through an automatic vehicle wash. If it is left on the outside it may be

knocked off and scratch the vehicle body.

• Do not paint the GPS aerial, as this may affect its performance.

Dashboard

Roof

Rear shelf

Boot lid

• The aerial should be installed on a

level surface where radio waves will

be blocked as little as possible. Radio

waves cannot be received by the aerial

if reception from the satellite is

blocked.

Installation on the vehicle roof or boot

lid is recommended to enable best

reception.

ENG/MASTER 96

CRD3647A_inst_001_029_UK 4/15/02 2:03 PM Page 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 171 172

Pas de commentaire

Pioneer AVIC-70D-2 Manuel d'utilisateur Page 20