Pioneer AVH-X2650BT Manuel d'utilisateur Page 50

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 200
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 49
Black plate (50,1)
2 Install the microphone on the steering
column.
1
2
1 Double-sided tape
2 Install the microphone on the rear side of the
steering column.
Adjusting the microphone angle
Troubleshooting
Symptoms are written in bold and causes in reg-
ular, non-indented text. Regular, indented text is
used to indicate actions to be taken.
Common
The power will not turn on.
The unit will not operate.
Leads and connectors are incorrectly connected.
Confirm once more that all connections are
correct.
The fuse is blown.
Rectify the cause and then replace the fuse. Be
sure to install a fuse with the same rating.
Noise and/or other factors are causing the built-in
microprocessor to operate incorrectly.
Press RESET. (Page 43)
Operation with the remote control is not possi-
ble.
The unit does not operate correctly even when
the appropriate remote control buttons are
pressed.
Battery power is low.
Load a new battery.
Some operations are prohibited with certain discs.
Try operating with another disc.
Playback is not possible.
The disc is dirty.
Clean the disc.
The type of disc loaded cannot be played on this
unit.
Check the disc type.
The disc loaded is not compatible with this video sys-
tem.
Change the disc to one that is compatible with
your video system.
There is no sound.
The volume level will not rise.
Cables are not connected correctly.
Connect the cables correctly.
The unit is performing still, slow motion or frame-by-
frame playback.
There is no sound during still, slow motion or
frame-by-frame playback.
There is no image displayed.
The parking brake cable is not connected.
Connect the parking brake cable, and apply the
parking brake.
The parking brake is not applied.
Connect the parking brake cable, and apply the
parking brake.
The
icon is displayed, and operation is not
possible.
The operation is prohibited for the disc.
This operation is not possible.
The operation is not compatible with the configura-
tion of the disc.
This operation is not possible.
The image displayed stops (pauses) and the unit
cannot be operated.
The data could no longer be read during playback.
Stop playback once, and start playback again.
There is no sound.
The volume level is low.
The volume level is low.
Adjust the volume level.
The attenuator is on.
Turn the attenuator off.
The sound and video skip.
The unit is not firmly secured.
Firmly secure the unit.
Installation
50
Section
Additional information
En
25
<CRD4760-A>50
Vue de la page 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 199 200

Commentaires sur ces manuels

Pas de commentaire