Pioneer AVIC-N3 Manuel d'opérations Page 139

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 160
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 138
137
AppendixNAVI/AV
Your vehicle is operating in Simple
hybrid mode.
Connect the speed signal input (pink
lead wire) of the power cable cor-
rectly, and reset the 3D Hybrid Sen-
sor memory (“Learning Status”).
The navigation system is installed
with an extreme angle exceeding the
limitation of the installation angle.
Confirm the installation angle. (The
navigation system must be installed
within the allowed installation angle.
For details, refer to “Installation Man-
ual”.)
Indication of the position of your vehi-
cle is misaligned after a U-turn or
reversing.
Check whether or not the reverse
gear signal input lead (purple) is con-
nected properly. (The navigation sys-
tem works properly without the lead
connected, but positioning accuracy
will be adversely affected.)
The map continually reorients itself. The traveling direction is always set
to Heading Up.
Touch on the screen and change
the map display.
Tracking marks are not displayed. The “Tracking Display” is turned
off.
Check the “Tracking Display” set-
tings ( Page 70) and make sure
Always” or “This Trip” is selected.
The daylight display is used even
when the vehicle lights are on.
Daytime is selected to “Day/Night
Display”.
Check the “Day/Night Display” set-
ting ( Page 70) and make sure
Nighttime” is selected.
The orange/white lead is not con-
nected.
Check the connection.
The system will not switch on or will
not operate.
Installation or connection has been
carried out incorrectly.
Check with your dealer.
The display is very dim. The vehicle’s light is turned ON, and
Nighttime” is selected on “Day/
Night Display”.
Read about the “Day/Night Dis-
play” setting ( Page 70) and, if
desired, select “Daytime”.
The vehicle cabin temperature is
extremely low.
A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the vehi-
cle to warm up.
Picture quality adjustment of the dis-
play is not correct.
Refer to “Hardware Manual” to adjust
the picture quality.
Ambient light sensor of the display is
hidden.
Set the ambient light sensor not to
be hidden.
There is no voice guidance or the vol-
ume is low.
The volume setting is low or the
speaker lead is disconnected.
Check the volume setting on the dis-
play or turn the volume up according
to “Volume” ( Page 67) and/or turn
up the volume on the display.
Slope is not displayed on the
Vehicle Dynamics screen.
Inclination does not move on the 3D
Calibration screen.
The speed pulse lead is not con-
nected.
Connect the speed pulse lead.
When the screen is frozen...
Park your vehicle at a safe place, and cut off the engine. Turn the ignition key back to “Acc off”. Then
start the engine again, and turn the power to the navigation system back on. If this does not solve the
problem, press the RESET button on the navigation system.
Symptom Cause Action (See)
Vue de la page 138
1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 159 160

Commentaires sur ces manuels

Pas de commentaire