Pioneer UDP-LX500 Manuel d'utilisateur télécharger pdf (Page 40)

Audio Output

Digital Output Bitstream Select this to output digital audio signals directly.

PCM Select this to output digital audio signals converted to 2-channel

audio signals.

Reencode When a BD containing secondary audio and interactive audio is

played, the two audio signals are mixed and converted to Dolby

Digital audio or DTS audio for output.

Off Select this to output audio signals other than digital audio signals.

Downmix Stereo Surround audio signals converted to linear PCM audio signals are

converted into 2-channel (stereo) signals for output.

Lt/Rt Surround for output (when the connected AV receiver or amplifier,

etc., is compatible with Dolby Pro Logic, the AV receiver or amplifier

outputs the linear PCM audio signals as surround audio signals).

Max Sampling

Frequency

48kHz Outputs audio signals that are limited to a sampling frequency

below the set sampling frequency from the DIGITAL OUT terminal.

Select according to the performance of the connected device.

96kHz

192kHz

• When playing back a sampling frequency file or a disk having a lower than or equal setting compared to the

present setting, you can output it at the unchanged sampling frequency.

• Sources with sampling frequencies of over 192 kHz cannot be played.

• When playing copyright-protected discs or files, the signals are output with the sampling frequency limited to

48 kHz or below, regardless of this setting.

DRC (Dynamic Range

Control)

Off Select this to output audio signals without using the DRC function.

On Select this to adjust the range between the loudest and softest

sounds (dynamic range) for playback at average volume. Use this

when it is hard to hear dialog or when watching movies at midnight.

Auto Select to switch the DRC setting On/Off automatically according to

the input audio signal from the disc. This only affects Dolby TrueHD

signals.

• This affects such audio signals as Dolby Digital, Dolby TrueHD, and Dolby Digital Plus.

• DRC affects audio signals output from the following audio output terminals:

– Analog audio signals output from the AUDIO OUT terminals

– Linear PCM audio signals output from the DIGITAL OUT or HDMI OUT terminals

• Depending on the disc, the effect may be weak.

• The effect may differ depending on the speakers, the AV amplifier settings, etc.

Setting Options Explanation

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

Pas de commentaire

Pioneer UDP-LX500 Manuel d'utilisateur Page 40