Pioneer PDP-5000EX Manuel d'utilisateur Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 230
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
29
En
Basic Adjustment Settings
09
English
Power Control
Power Control provides convenient functions for power saving.
Energy Save
You may use one of the two Energy Save modes to save power
consumption.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER (ENTER/DISP.)).
3 Select “Energy Save” ( / ).
4 Select “Save 1” or ”Save 2” ( / ).
5 Press HOME MENU, INPUT 1 to INPUT 6 (INPUT) to exit
the menu.
No Signal off
The Plasma Display will be automatically placed into the
standby mode if no signal is received for 8 minutes.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER (ENTER/DISP.).
3 Select “No Signal off” ( / ).
4 Select ”Enable” ( / ).
5 Press HOME MENU, INPUT 1 to INPUT 6 (INPUT) to exit
the menu.
NOTE
INPUT1 to INPUT6 are enabled. INPUT1 and 4 are disabled,
however, when they have “Signal Type” set to “PC.”
Operation is disabled during display of the HOME MENU.
•A message will be displayed immediately before the Plasma
Display enters standby mode.
Power Management
The Plasma Display will be automatically placed into the
standby mode when no signal is received.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER (ENTER/DISP.)).
3 Select “Power Management” ( / ).
4 Select “Enable” ( / ).
5 Press HOME MENU, INPUT 1 to INPUT 6 (INPUT) to exit
the menu.
NOTE
INPUT1 and INPUT4 only are enabled. However, when
“Signal Type” is set to “AV”, they are disabled.
Operation is disabled during display of the HOME MENU.
Item Description
Standard Does not decrease the picture brightness.
Save1 Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Save2 Decreases the picture brightness and lowers
power consumption.
Item Description
Disable Does not place the Plasma Display into the
standby mode.
Enable Places the Plasma Display into the standby
mode if no signal is received for 8 minutes.
Item Description
Disable No power management
Enable If no input signal is detected for one minute or
more, the unit automatically enters the standby
mode. If a signal is subsequently detected, the
unit automatically turns ON.
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 229 230

Commentaires sur ces manuels

Pas de commentaire