Pioneer VSX-45TX Manuel d'utilisateur télécharger pdf (Page 115)

115

Techno Tidbits & Problem-solving

EXPERT

During playback of a 96kHz

source, the display doesn't

show 96kHz

Remote control

Cannot be remote

controlled.

Other components can't be

operated with the system

remote.

The SR cable is connected,

but the connected

components can't be

operated with the remote.

Miscellaneous

There seems to be a time lag

between the speakers and

the output of the subwoofer.

• SIGNAL SELECT is set to ANALOG

• The remote control batteries have worn

out.

• Too far away or improper angle of

operation.

• There is an obstacle between the

receiver and the remote control.

• Strong light such as fluorescent light is

shining onto the unit's remote control signal

light-receiving window.

• A cord is connected to the CONTROL IN

terminal on this unit.

• The IR Receiver type is mismatched with

the setting.

• The preset code settings are wrong.

• The batteries wore out and the system

settings were cleared.

• The SR cable hasn't been connected

properly.

• The rest of the component connection

have not been made.

• The component you have hooked up is

not SR compatible.

• The subwoofer channel can be delayed

slightly if run through a low-pass filter.

• SET the SIGNAL SELECT to AUTO (see

page 45).

• Replace the batteries (see page 7).

• Operate within 25 feet and a 30° angle of

the remote sensor on the front panel (see

page 8).

• Remove the obstacle or operate from

another position (see page 8).

• Avoid exposing the remote sensor on the

front panel to direct light.

• Connect cord to the correct jack.

• Disconnect the IR Receiver from the rear

panel, and set to the other IR Receiver type

using the remote control.

• Input the correct preset code.

• Reset the proper system settings.

• Reinsert the SR cable, making sure it is

the right jack (see page 79).

• Make sure an analog connection has

been made between the units.

• This is not a malfunction.

• The MCACC system will automatically

compensate for a delay in the subwoofer

output during the Auto Surround Sound

Setup.

Symptom Cause Remedy

If the unit does not operate normally due to external effects such as static electricity

Disconnect the power plug from the outlet and insert again to return to normal operating conditions.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120

Commentaires sur ces manuels

Pas de commentaire

Pioneer VSX-45TX Manuel d'utilisateur Page 115

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Pioneer VSX-45TX