Pioneer VSX-45TX Manuel d'utilisateur Page 45

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 120
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 44
45
BASIC
Switching ANALOG/DIGITAL Signal Input
This button selects the type of input signal, ANALOG or DIGITAL, sent to the receiver. You need to take special
care to switch to the appropriate input when necessary. For example, the switch would have to be on DIGITAL
to hear digital sources like Dolby Digital or DTS but it would have to be on analog to record from the ANALOG
out jacks on the receiver. The default setting is AUTO (which chooses digital over analog when both are
available but goes with whatever is available) for: DVD/LD, TV/SAT, VIDEO, CD, CDR/TAPE1. The default setting
is ANALOG for: VCR1/DVR, VCR2, MD/TAPE2, TUNER, PHONO. The default setting is DIGITAL for USB.
1
Press RECEIVER.
2
Press the SIGNAL SELECT button to
select the input signal corresponding
to the format of the source
component.
Each press switches the signal in the order below:
AUTO ANALOG DIGITAL
memo
When DIGITAL signal is selected, 2 DIGITAL lights when a Dolby Digital signal is input; DTS lights when a
DTS signal is input.
If no digital inputs are assigned (see page 91) you can only choose ANALOG in the SIGNAL SELECT.
Because the audio signal from a karaoke microphone and LDs are recorded with analog audio only, they are
not output from the digital outputs. Set SIGNAL SELECT to ANALOG to listen to these formats.
When an LD with DTS is played back with the SIGNAL SELECT set in ANALOG, digital noise caused by
playing back the DTS signal directly (with no decoding) is output. To prevent noise, you need to make digital
connections (See pages 22 & 23) and set SIGNAL SELECT to AUTO or DIGITAL.
Some DVD players dont output DTS signals. For more details, refer to the instruction manual supplied with
your DVD player.
This receiver can only play back Dolby Digital, PCM (32kHz, 44.1kHz, 48kHz, 88.2kHz and 96kHz sampling
frequency), and DTS digital signal formats. If your source is not one of these select ANALOG for playback.
2
Basic Operation
PHONES
SPEAKERS
SIGNAL
SELECT
SB CH
MODE
HI-BIT
HI-SAMPLING
SETUP
MIC
DIGITAL IN
S-VIDEO VIDEO
VIDEO INPUT
AUDIOL
R
SET UP RETURN
TONE
TONE CONTROL
BASS/TREBLE
CLASSBAND
STATION TUNING
MULTI ROOM
MULTI JOG/ENTER
CONTROL ON/OFF
& SOURCE
MULTI JOG CONTROL
SELECT
TUNER
EDIT
OFF
S0URCE TV
MULTI CONTROL
SYSTEM
RECEIVER
DVD/LD TV/SAT TV CONT
VCR1/
DVR
VCR2 VIDEO CD
MULTI
OPERATION
DIMMER
MD/
TAPE2
CD-R/
TAPE1
TUNER
RECEIVER
1
2
LOUDNESS TONE
3
4
DNR
5
SIGNAL SEL
VIDEO SEL HI-BIT
6
D RECT ACCESS SEARCH MODE
+
+
10
DISC
ENTER
7
EFFECT/CH SEL
8
9
BASS/TREBLE
0
SETUP
2
1
Vue de la page 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 119 120

Commentaires sur ces manuels

Pas de commentaire