Pioneer DEH-P670MP Manuel d'utilisateur télécharger pdf (Page 42)

1 Press FUNCTION to select AUX.

Press FUNCTION repeatedly until AUX ap-

pears in the display.

2 Press a or b to turn AUX on or off.

Pressing a or b will turn AUX on or off and

that status will be displayed (e.g.,

AUX :ON).

Switching the dimmer setting

To prevent the display from being too bright at

night, the display is automatically dimmed

when the cars headlights are turned on. You

can turn the dimmer on or off.

1 Press FUNCTION to select Dimmer.

Press FUNCTION repeatedly until Dimmer ap-

pears in the display.

2 Press a or b to turn Dimmer on or off.

Pressing a or b will turn Dimmer on or off

and that status will be displayed (e.g.,

Dimmer :ON).

Adjusting the brightness

You can adjust the display brightness. Initially

this mode is set to 12.

1 Press FUNCTION to select Brightness.

Press FUNCTION repeatedly until Brightness

appears in the display.

2 Press c or d to adjust the brightness

level.

Each press of c or d increases or decreases

the brightness level. 0  15 is displayed as the

level is increased or decreased.

Setting the rear output and

subwoofer controller

This units rear output (rear speaker leads out-

put and RCA rear output) can be used for full-

range speaker (REAR SP :FULL) or subwoofer

(REAR SP :S/W) connection. If you switch the

rear output setting to the REAR SP :S/W, you

can connect a rear speaker lead directly to a

subwoofer without using an auxiliary amp.

Initially, the unit is set for rear full-range speak-

er connection (REAR SP :FULL). When rear

output is connected to full range speakers

(when REAR SP :FULL is selected), you can

connect the RCA subwoofer output to a sub-

woofer. In this case, you can select whether to

use the subwoofer controllers (low pass filter,

phase) built-in PREOUT:S/W or the auxiliary

PREOUT:FULL.

1 Press FUNCTION to select REAR SP.

Press FUNCTION repeatedly until REAR SP ap-

pears in the display.

2 Press a or b to switch the rear output

setting.

Pressing a or b will switch between

REAR SP :FULL (full-range speaker) and

REAR SP :S/W (subwoofer) and that status will

be displayed.

# When no subwoofer is connected to the rear

output, select REAR SP :FULL.

# When a subwoofer is connected to the rear

output, set for subwoofer REAR SP :S/W.

# When the rear output setting is

REAR SP :S/W, you cannot change the subwoofer

controller.

3 Press c or d to switch the subwoofer

output or nonfading output (full-range

RCA output).

Pressing c or d will switch between

PREOUT:S/W and PREOUT :FULL and that

status will be displayed.

Initial Settings

En

42

Section

09

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 117 118

Commentaires sur ces manuels

Pas de commentaire