Pioneer XW-NAC3-R Manuel d'utilisateur Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 132
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
iPod/iPhone playback03
14
En
SHUFFLE
2
Two iPod/iPhone units can be played
alternately with no break in sound (SHUFFLE
2
).
A bit before the currently playing iPod/iPhone
track ends, playback begins on the other iPod/
iPhone track and the volume is gradually
raised to fade in seamlessly (Cross fade).
During the SHUFFLE
2
operation, the order of
track playback is set by the shuffle function.
1 Connect two iPod/iPhone units to the
iPod/iPhone connector ports (
iPod a
,
iPod b
),
then press
iPod a
or
iPod b
.
2Press
MENU
to access the iPod/iPhone
menu.
3 Select the track area that you want to
play back, then press
ENTER
.
4Press .
The SHUFFLE
2
mode is set, and the SHUFFLE
2
indicator lights; the unit connected to the iPod
a connector port will playback.
A bit before the currently playing iPod/iPhone
track ends, the other iPod/iPhone unit begins
cross fade playback. The same operation is
repeated thereafter until all tracks on both
units have been played.
1
To cancel the SHUFFLE
2
mode, press either
once again, or .
•The SHUFFLE
2
mode will also be canceled
if the function is switched to any another
input (including iPod a or iPod b).
HI-LITE Scan
Each track is played back for a few seconds at
a certain time from the track beginning, thus
allowing desired tracks to be found quickly.
1 Connect an iPod/iPhone to the iPod/
iPhone connector ports, then press
iPod a
or
iPod b
.
2 Press
MENU
to access the iPod/iPhone
menu.
3 Select the track area that you want to
play back, then press
ENTER
.
4 Press
HI-LITE
.
HI-LITE scan function will begin from the first
track on the selected iPod/iPhone.
If playback was already underway, the HI-LITE
scan will begin from the currently playing
track.
After a track is played for a few seconds, the
next track will be found and a certain time
2
from the track beginning will be played for a
few seconds.
When two iPod/iPhone units are connected
simultaneously, the first track on the alternate
iPod/iPhone will be found and a certain time
from the track beginning will be played for a
few seconds.
Thereafter, the same process will be repeated
until all tracks have been found and played for
a few seconds each.
To cancel the HI-LITE Scan operation,
press HI-LITE once more.
The HI-LITE Scan mode will also be
canceled if the function is switched to any
another input (including iPod a or iPod b).
Note
1 During Cross Fade operation, /, and / are deactivated.
2 If a tracks total length is too short, the track will be played back from the track beginning for a few seconds.
XW-NAC3_SYXJ.book 14 ページ 2010年3月25日 木曜日 午後7時21分
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 131 132

Commentaires sur ces manuels

Pas de commentaire