Pioneer XW-NAC3-R Manuel d'utilisateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 132
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
Bluetooth
® AUDIO for Wireless Enjoyment of Music
04
17
En
English
Français Español
Setting the PIN code
Set this unit’s PIN code to the same setting as
that for the Bluetooth wireless technology
device used. Supported PIN code setting
values include 0000, 1234 or 8888.
Default setting: 0000
1 Press
BT A
.
When the Bluetooth wireless technology
device is not connected, ‘Device
Disconnected’ is displayed. If the Bluetooth
wireless technology device is connected,
disconnect it.
2 When ’Device Disconnected’ is displayed,
press and hold
VOLUME –
on the top panel,
and then press and hold
STANDBY/ON
for
three seconds.
The PIN code will be changed, and the newly
set PIN code will be displayed. Choose
between ‘0000’, ‘1234’ and ‘8888’.
Repeat step 2 until the PIN code is reset to the
value desired.
These settings are preserved in memory even
when the power is turned OFF. When resetting
the PIN code, turn the power ON, and perform
step 2 without any unit connected.
Pairing this unit and
Bluetooth
wireless technology device
“Pairing” must be done before you start
playback of Bluetooth wireless technology
content using Bluetooth AUDIO. Make sure to
perform pairing first time you operate the
system or any time pairing data is cleared.
“Pairing” is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
1
For more details,
see also the operating instructions of your
Bluetooth wireless technology device.
1Press
BT A
.
When the Bluetooth wireless technology
device is not connected, ‘Device
Disconnected’ is displayed. If the Bluetooth
wireless technology device is connected,
disconnect it.
2 When ’Device Disconnected’ is displayed,
press
.
‘Pairing’ will be displayed, and the unit will
enter the pairing standby mode.
3 Switch on the
Bluetooth
wireless
technology device that you want to perform
pairing with, place the device within 1 meter
of the system, and set it to the pairing mode.
Pairing begins.
4 Check to see that the
Bluetooth
AUDIO is
detected by the
Bluetooth
wireless
technology device.
‘Device Connected’ is displayed when
Bluetooth wireless technology device is
connected. Then the connected device name is
displayed.
STANDBY/ON
VOLUME
a
INPUT
SELECTOR
ba
TIMER
WAKE UP(GREEN)
SLEEP(ORANGE)
USB
Note
1 • Pairing is required when you first use Bluetooth wireless technology device and this unit.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
XW-NAC3_SYXJ.book 17 ページ 2010年3月25日 木曜日 午後7時21分
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 131 132

Commentaires sur ces manuels

Pas de commentaire