Pioneer PDK-TS24 Manuel d'utilisateur télécharger pdf (Page 6)

11 (13/32)

Side View

12 mm to 15 mm

(1/2 to 5/8 inch)

Using a wall for stabilization

1 Attaching falling prevention bolts to the

Plasma Display.

2 Using strong cords to firmly stabilize it

appropriately and firmly to a wall, pillar, or

other sturdy element.

Perform this work in the same way on the left and right

sides.

Note

Use hooks, ropes, and fittings

that are available on the market.

Recommended hook:

Nominal diameter M8

Length 12 mm to 15 mm (1/2 to 5/8 inch)

1 Hook

2 Cords

Fittings

Stabilizing on TV table or other location

Stabilize the equipment as shown in the diagram using

screws that are available on the market.

Note

To stabilize the Plasma Display on a TV table, use screws that

have a nominal diameter of 6 mm (1/4 inch).

Select the appropriate screws after consulting a professional

installer if necessary.

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.

 Because of the plasma display’s weight, if it could fall down, this can result in injury.

 For safety, be sure to take special care to ensure that the Plasma Display will not fall over.

 Position of table screws

To stabilize the Plasma Display on a TV table, use screws

that have a nominal diameter of 6 mm (1/4 inch).

Unit: mm (inch)

*: 50 inch display model

**:42 inch display model

301 (11-27/32) 24 (15/16)

120

(4-23/32)

460(18-1/8 )**

552(21-23/32 ) *

Preventing Equipment from Falling Over

Dimension without speakers

Caution

• A TV table with adequate strength should always be

used to support the Plasma Display.

Failure to do so could result in personal injury and

physical damage.

• If you do not take these precautions, the Plasma

Display could fall down and cause injury.

• The screws, hooks and other fittings that you use to

secure the Plasma Display to prevent it from

overturning will vary according to the composition and

thickness of the surface to which it will be attached.

• Select the appropriate screws, hooks and other fittings

after first inspecting the surface carefully to determine

its thickness and composition and after consulting a

professional installer if necessary.

Min. 20 mm

(13/16 inch)

9 mm to 15 mm

(3/8 to 5/8 inch)

6 mm

(1/4 inch)

1 2 3 4 5 6 7 8 9 10 11 ... 50 51

Commentaires sur ces manuels

Pas de commentaire

Pioneer PDK-TS24 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer PDK-TS24