Pioneer CP-LX70 Manuel d'utilisateur télécharger pdf (Page 3)

English Français Español

Installing the speaker stands

• Place the stand on a stable, level surface; placing the stand on

an unstable surface can be dangerous.

When placing the speaker, keep in mind that the tone is affected by

the position of the speaker.

If the bass is insufficient, move the speaker closer to the wall. The

richest bass sound is obtained when the speaker is right against

the wall. If the bass is too powerful, producing a muffled tone, move

the speaker away from the wall. Placing the speaker against a thick

curtain may also be effective.

Adjust the position as necessary to obtain optimal sound from your

system.

Assembling the speaker stands

Make sure you assemble the stand on a flat surface that is relatively

soft (such as a carpet).

A medium-sized Phillips screwdriver is required for assembly.

• The Styrofoam cushions are used during assembly.

CP-LX70 only:

Confirm that the surfaces with printing are

facing upwards and oriented as shown, then align the top

cushion on the bottom cushion as illustrated.

1 Run the speaker cable through the pillar and place the pillar

onto the stand base.

Place the pillar on a flat surface and cut the string that is strung

through the pillar. Tie the speaker cable coming out of the stand

base to the end string at the bottom of the pillar. Pull the end of the

string emerging from the top front side of the pillar to pull the

speaker cable up through the pillar.

• Remove the string once the speaker cable is through the pillar.

Next, stand the pillar upright and fit the bottom of the pillar into the

stand base, making sure that the pillar is aligned with the hole in

the stand base.

• When fitting the pillar into the stand base, make sure that the

speaker cable comes through the groove on the bottom of the

pillar and does not get pinched between the pillar and the stand

base.

• Make sure not to scratch the surface of the stand base with the

pillar, as the decorative laminate of the stand base may scar

easily.

The pillars and speaker stand bases are designed with specific

directional orientation for assembly. During assembly, make sure

they are attached in the correct directions.

Front side Rear side

Cushioning

material (Top)

Cushioning

material (Bottom)

01_CP-LX70.book 3 ページ２００７年１０月１２日　金曜日　午後３時３０分

1 2 3 4 5 6 7 8 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Pioneer CP-LX70 Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Pioneer CP-LX70