Pioneer V8000 Manuel d'utilisateur télécharger pdf (Page 10)

Computer Control

- 3

Refer to the instruction manual about ‘STOP ST’.

9-pin D-Sub connector

Pin # Terminal Input/Output Function

1 NC

2 RxD Input receive data

3 TxD Output send data

4 DTR Output data terminal ready

5 GND -- ground

6 NC

7 RTS Output

8 CTS Input

CTS is returned to RTS as

it is.

9 NC

2.3 Computer Control Functions

2.3.1 Serial Control (see Chapters 3, 4, 5 and 6)

The player and computer are based upon the RS-232C protocol and

are connected through the TxD, RxD, DTR and GND terminals.

2.3.2 Extend Terminal Control (see Chapter 9)

Control the player with the Extend Terminal Switches (SW#).

Even if the Key Lock is set (active), the extend terminal control is

available.

2.3.3 External Power Control

Control the player’s power with the Power Pin within the Interface

Connector.

If the player detects a high signal throughput (100m/sec or more)

during the Standby mode, the player powers ON. If the player

detects the same signal during the Power ON mode, the player

powers OFF and switches to the Standby mode.

The specifications for the Power pin are as follows:

Maximum Input Voltage Less Than 12V

High Level Signal More Than 3.3V

Low Level Signal Less Than 0.5V

Standby mode

more than

100 msec

Power ON

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 110 111

Pas de commentaire

Pioneer V8000 Manuel d'utilisateur Page 10