Pioneer DEH-P8400MP Manuel d'utilisateur télécharger pdf (Page 52)

09

Section

Selecting the illumination color

This product is equipped with two illumination

colors, green and red.

You can select the desired illumination color.

1 Press

OPEN to open the front panel.

2 Press FUNCTION to select ILL.

Press

FUNCTION until ILL appears in the dis-

play.

3 Select the desired illumination color with

2/3.

Pressing 2/3 will switch ILLUMI between red

or green and that status will be displayed (e.g.,

ILLUMI :GRN).

Setting the rear output and sub-

woofer controller

This product’s rear output (rear speaker leads

output and RCA rear output) can be used for

full-range speaker (Rear SP:FULL) or subwoofer

(Rear SP:S.W) connection. If you switch rear

output setting to the Rear SP:S.W, you can con-

nect a rear speaker lead directly to a subwoofer

without using an auxiliary amp.

Initially, the unit is set for rear full-range speaker

connection (Rear SP:FULL).

When rear output are connected to full range

speakers (when Rear SP:FULL is selected), you

can connect the RCA subwoofer output to a

subwoofer. In this case, you can select whether

to use the subwoofer controller’s (low pass

filter, phase) built-in S.W Control:INT or the

auxiliary

S.W Control:EXT.

Notes

• Even if you change this setting, there is no

output unless you switch the non fading out-

put (refer to page 47) or subwoofer output

(refer to page 46) in the Audio Menu on.

• If you change the subwoofer controller, sub-

woofer output and non fading output in the

Audio Menu return to the factory settings.

• Both rear speaker leads output and RCA rear

output are switched simultaneously in this

setting mode.

1 Press

OPEN to open the front panel.

2 Press FUNCTION to select SW.

Press FUNCTION until SW appears in the dis-

play.

3 Change the rear output setting with 5/∞.

Pressing 5/∞ will switch between Rear SP

:FULL (full-range speaker) and Rear SP:S.W

(subwoofer) and that status will be displayed.

Notes

• When no subwoofer is connected to the rear

output, select Rear SP:FULL.

• When a subwoofer is connected to the rear

output, set for subwoofer Rear SP:S.W.

• When the rear output setting is Rear SP:S.W,

you cannot change the subwoofer controller.

4 Change the subwoofer controller with

2/3.

Pressing 2/3 will switch between

S.W Control:INT and S.W Control:EXT and that

status will be displayed.

Initial Settings

En

52

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 131 132

Commentaires sur ces manuels

Pas de commentaire