Pioneer AVX-P7000CD Manuel d'utilisateur télécharger pdf (Page 13)

Connecting the Units

Note:

• This product is for vehicles with a 12-volt battery

and negative grounding. Before installing it in a

recreational vehiele, truck, or bus, check the bat

tery voltage.

• To avoid shorts in the electrieal system, be sure

to disconnect the © battery cable before begin

ning installation.

• Refer to the owner’s manual for details on con

necting the power amp and other products, then

make conneetions correctly.

• Secure the wiring with cable clamps or adhesive

tape. To protect the wiring, wrap adhesive tape

around them where they lie against metal parts.

• Route and secure all wiring so it cannot touch

any moving parts, such as the gear shift, hand

brake and seat rails. Do not route wiring in

places that get hot, such as near the heater outlet.

If the insulation of the wiring melts or gets torn,

there is a danger of the wiring short-circuiting to

the vehicle body.

• Don’t pass the yellow lead through a hole into

the engine compartment to conneet to the battery.

This will damage the lead insulation and cause a

very dangerous short.

• Do not shorten any leads. If you do, the protec

tion circuit may fail to work when it should.

• Never feed power to other equipment by cutting

the insulation of the power supply lead of this

produet and tapping into the lead. The current

capacity of the lead will be exeeeded, causing

overheating.

• When replacing fuse, be sure to use only fuse of

the rating prescribed on the fuse holder.

• To prevent incorreet connection, the input side of

the IP-BUS connector is blue, and the output side

is black. Connect the connectors of the same col

ors correctly.

If this product is installed in a vehicle that does

not have an ACC (accessory) position on the

ignition switch, the red lead of this product

should be connected to a terminal coupled with

ignition switch ON/OFF operations. If this is not

done, the vehicle battery may be drained when

you are away from the vehicle for several hours.

ACC position

No ACC position

A CAUTION

Cords for this product and those for

other products may be different colors

even if they have the same function.

When connecting this product to anollicr

product, refer to the supplied Installation

manuals of both products and connect

cords that have the same function.

About the V.SEL cable

Use to eonneet to an Audio Visual Master Unit,

TV tuner or other component featuring a V.SEL

cable connection jack. If you have an Audio

Visual Master Unit and a TV tuner, give priority

to eonnection of the Audio Visual Master Unit.

Note:

• When connecting the TV tuner refer to the TV

tuner Installation Manual.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Pioneer AVX-P7000CD Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Multimédia automobile Pioneer AVX-P7000CD