Pioneer AVIC-HD3-II Manuel d'utilisateur télécharger pdf (Page 153)

You cannot position your vehicle

on the map or the positioning

error is large.

The quality of signals from the GPS

satellites is poor, causing reduced

positioning accuracy. Such a loss of

signal quality may happen for the

following reasons:

• The GPS aerial is in an unsuitable

location.

• Obstacles are blocking signals

from the satellites.

• The position of satellites relative to

your vehicle is bad.

• Signals from the GPS satellites

have been modified to reduce accu-

racy. (GPS satellites are operated by

the US Department of Defense, and

the US government reserves the

right to distort positioning data for

military reasons. This may lead to

greater positioning errors.)

Check the GPS signal reception and the posi-

tion of the GPS aerial if necessary, or con-

tinue driving until reception improves. Keep

the aerial clear. (Page 74)

You cannot position your vehicle

on the map or the positioning

error is large.

The quality of signals from the GPS

satellites is poor, causing reduced

positioning accuracy. Such a loss of

signal quality may happen for the

following reasons:

• If a vehicle phone or mobile

phone is used near the GPS aerial,

GPS reception may be lost tempora-

rily.

• Do not cover the GPS aerial with

spray paint or vehicle wax, because

this may block the reception of GPS

signals. Snow buildup can also de-

grade the signals.

Check the GPS signal reception and the posi-

tion of the GPS aerial if necessary, or con-

tinue driving until reception improves. Keep

the aerial clear. (Page 74)

Signals from the vehicle’s speed

pulse are not being picked up prop-

erly.

Check that the cables are properly connected.

If necessary, consult the dealer that installed

the system.

The navigation system may not be

mounted securely in your vehicle.

Check that the navigation system is securely

mounted and, if necessary, consult the dealer

that installed the system.

Your vehicle is operating in Simple

hybrid mode.

Connect the speed signal input (pink lead

wire) of the power cable correctly, and reset

the 3D Hybrid Sensor memory ([Learning

Status]).

The navigation system is installed

with an extreme angle exceeding

the limitation of the installation

angle.

Confirm the installation angle. (The naviga-

tion system must be installed within the al-

lowed installatio n angle. For details, refer to

“Installation Manual” and [Installation

Angle Setup].) (Page 76)

Indication of the position of your ve-

hicle is misaligned after a U-turn or

reversing.

Check whether or not the reverse gear signal

input lead (violet) is connected properly. (The

navigation system works properly without the

lead connected, but positioning accuracy will

be adversely affected.)

Appendix

Engb

153

Appendix

Appendix

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 188 189

Commentaires sur ces manuels

Pas de commentaire