Pioneer Plasma Display Monitor 502MX Manuel d'utilisateur télécharger pdf (Page 76)

Speaker System

4.9.3 Mounting to the main unit

1) Installing procedure

Install the speaker according to the procedure (1)

through (3) below:The illustrations below show the

speaker (for right) to be mounted to the right of

the display.

Caution:

When the speaker is mounted to the display, the op-

eration panel of the display cannot be used. A remote

controller supplied to the display should be used.

(1) Affixing the mounting plate to the speaker

Note : Mounting plates should be attached to speakers

only when speakers are attached to the display.

(2) Installing the metal fixture on the speaker

• Washers M8 (

25) are supplied for third-party metal

fixtures.

• Mount commercial fixtures by the two-point mounting

method to the mounting holes provided at the center

or bottom of the back of the speaker. These mounting

holes are at different levels. To make the hole levels

even, use additional washers until they are flush.

Hole rivet

Hexagon socket

screws

Plasma display

1. Make sure of right and left speakers by

confirming the indication of "Right" and

"Left" on the rear side. Set the mount-

ing plate to the corresponding speaker

so as to get a proper combination of

speaker and mounting plate.

2. Peel off two seals at the affixing plane

on the mounting plate.

3. Make sure of the position to be affixed

and affix the mounting plate to the side

of the speaker.

Set the mounting plate to 0.5 to 1cm be-

low the top of the speaker.

Mounting plate

Seal (2 places)

1. Since the upper metal fix-

tures are distinguished be-

tween right and left ones,

make sure of speakers and

right and left metal fixtures

properly before setting up.

2. Install the metal fixtures at

the position as shown in the

figure to the left.

Mounting metal

fixture (for upper

side)

Countersunk screw

Metal fixture (for lower side)

Mounting plate

(3) Installing the speaker to the side of the plasma

display

1. Remove the hole rivets (two places on a single side)

from the rear of the display (by turning the hole rivet

with a coin and so forth).

2. Make sure of right and left position by looking at the

indication of "Right" and "Left" on the rear side of the

speakers. With the "UP»" indication placed upward,

install the upper metal fixture first and then the lower

one on the display.

(To make allowance for clearance correction, tempo-

rarily install the display.)

3. Adjust the position of the display so that the clearance

between the speakers and the display is even, then

fully tighten the screws.

• When you install the speakers, using

screws other than those provided may

cause the speakers to fall or malfunction.

Use only the screws provided for

installation.

• When the display is to be moved after

installing the speakers, do not hold the

speaker itself. Please move the display

by holding its lower side.

Caution

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 142 143

Commentaires sur ces manuels

Pas de commentaire

Pioneer Plasma Display Monitor 502MX Manuel d'utilisateur Page 76

Commentaires sur ces manuels

Produits connexes et manuels pour Télévisions Pioneer Plasma Display Monitor 502MX