Pioneer DEH-P8MP Manuel d'utilisateur télécharger pdf (Page 54)

Adjusting initial settings

1

Initial settings lets you perform initial setup of

different settings for this unit.

1 Function display

Shows the function status.

1 Press SOURCE and hold until the unit

turns off.

2 Press Multi-Control and hold until the

clock appears in the display.

3 Turn Multi-Control to select one of the

initial settings.

Turn Multi-Control clockwise to switch be-

tween the functions in the following order:

ClockWarning (warning tone)AUX (aux-

iliary input) Dimmer (dimmer)Brightness

(brightness)REAR SP (rear output and sub-

woofer controller)Telephone (telephone

muting/attenuation)Motion (motion

screen)EVER-SCROLL (ever scroll)

Auto Open (flap auto open)

Use the following instructions to operate each

particular setting.

# To cancel initial settings, press BAND.

Setting the clock

Use these instructions to set the clock.

1 Use Multi-Control to select clock.

Clock appears in the display.

2 Push Multi-Control left or right to select

the segment of the clock display you wish

to set.

Pushing Multi-Control left or right will select

one segment of the clock display:

HourMinute

As you select segments of the clock display

the segment selected will blink.

3 Push Multi-Control up or down to set

the clock.

Pushing Multi-Control up will increase the

selected hour or minute. Pushing

Multi-Control down will decrease the se-

lected hour or minute.

Notes

! You can match the clock to a time signal by

pressing Multi-Control.

 If the minute is 0029, the minutes are

rounded down. (e.g., 10:18 becomes

10:00.)

 If the minute is 3059, the minutes are

rounded up. (e.g., 10:36 becomes 11:00.)

! Even when the sources are off, the clock dis-

play appears on the display.

Switching the warning tone

If the front panel is not detached from the

head unit within four seconds of turning off

the ignition, a warning tone will sound. You

can turn off the warning tone.

1 Use Multi-Control to select Warning.

Warning appears in the display.

Initial Settings

En

54

Section

12

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 139 140

Commentaires sur ces manuels

Pas de commentaire