Pioneer VSX-AX3-S Manuel d'utilisateur télécharger pdf (Page 85)

Expert System Settings

EXPERT

Fine Channel Level

The following steps show you how to balance the sound output level of your speakers more finely than in the

NORMAL setup (see page 38). Proper speaker balance is essential for obtaining high quality surround sound and

the better the speaker balance the better surround sound you can get.

Follow steps 1-5 on page 83, if necessary, to get to the

starting point mentioned here.

1 FINE CHANNEL LEVEL should be

selected, if it isn’t use the  buttons

to select and press ENTER.

2Use the  buttons to adjust the

level of the left channel. Press ENTER.

Test tones will be output.

WARNING: Be prepared! The test tones are output at

a high volume level.

MASTER VOLUME rotates to the reference position (0 dB)

and after a few seconds the test tone is output.

3Use the  buttons to select the

subsequent channel. Press ENTER.

4 Adjust the level of the channel using

the  buttons.

Adjust the channel level from –10dB to +10dB in 0.5dB

increments.

The default setting is 0dB.

Try to get the volume level of the target speaker to match

that of the front left speaker, which is the reference level.

Adjust so that you hear both tones at the same volume.

When you press ENTER you will automatically go to the

next channel.

5 Press ENTER to select a new channel.

Repeat step 3 for every channel.

If you want to change a setting before proceeding

Use the  buttons to go back to the channel you want

to adjust and press ENTER. Then follow step 3.

6 When done select EXIT (if it’s not

already selected) and press ENTER.

Next, if you want, proceed to FINE CHANNEL DELAY.

Left

1-6

00_VSX-AX3.book Page 85 Monday, May 19, 2003 1:05 PM

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 103 104

Pas de commentaire

Pioneer VSX-AX3-S Manuel d'utilisateur Page 85