Pioneer Super Tuner III D DEH-P80RS Manuel d'utilisateur télécharger pdf (Page 49)

F/B (balance adjustment)—POSI (position se-

lector)—TA1 (time alignment setting)—TA2

(time alignment adjusting)—LOUD (loudness)

—EQ 1 (graphic equalizer)—EQ 2 (16-band

graphic equalizer)—SW 1 (subwoofer on/off)

—SW 2 (subwoofer cut-off frequency)—SW 3

(subwoofer slope)—F.HPF 1 (front high pass

filter slope)—F.HPF 2 (front high pass filter

cut-off frequency)—R.HPF 1 (rear high pass fil-

ter slope)—R.HPF 2 (rear high pass filter cut-

off frequency)—BBE (BBE) —BMX (BMX and

compression)—A.EQ (auto-equalizer on/off)—

SLA (source level adjustment)

# You can also switch between the audio func-

tions in reverse order by turning

MULTI-CONTROL counterclockwise.

# When tuner, television or AUX is selected as a

source, you cannot select BMX.

# When selecting the FM tuner as the source,

you cannot switch to SLA.

# When selecting a source other than built-in

CD player, multi-CD player, DVD player/multi-DVD

player or iPod, you cannot select BMX.

# When selecting TA OFF in TA1, you cannot

switch to TA2.

# You can select SW 2 and SW 3 only when sub-

woofer output output is turned on in SW 1.

# To return to the display of each source, press

BAND.

Notes

! If you do not operate the audio function within

about 30 seconds, the display is automatically

returned to the source display.

! EQ 2 (16-band graphic equalizer), TA2 (time

alignment adjusting), NW 1 (network adjust-

ment 1), NW 2 (network adjustment 2), NW 3

(network adjustment 3) and NW 4 (network

adjustment 4) functions are not canceled

automatically.

Switching left and right

channel

You can adjust following functions for left and

right channel independently or commonly.

3-way network mode

! Adjusting network (NW 1, NW 2, NW 3)

! Adjusting 16-band graphic equalizer (EQ 2)

Standard mode

! Adjusting subwoofer settings (SW 2)

! Adjusting low pass filter attenuation slope

(SW 3)

! Setting the high pass filter for front speakers

(F.HPF 1, F.HPF 2)

! Setting the high pass filter for rear speakers

(R.HPF 1, R.HPF 2)

! Adjusting 16-band graphic equalizer (EQ 2)

1 Use MULTI-CONTROL to select the

audio function described above.

2 Press MULTI-CONTROL and hold to

switch between left/right independent

mode and left/right common mode.

Each pressing and holding MULTI-CONTROL

selects left/right independent mode and left/

right common mode.

3 Press MULTI-CONTROL to select left

channel or right channel when left/right in-

dependent mode has been selected.

Each pressing MULTI-CONTROL selects left

channel and right channel.

4 Adjust these functions as desired.

Audio Adjustments

En

49

English

Section

11

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 164 165

Commentaires sur ces manuels

Pas de commentaire