Pioneer CNDV-50MT Manuel d'utilisateur télécharger pdf (Page 95)

93

Chapter 8 Customising the Audio Source SettingAV

Switching Auto PI seek

The unit can automatically search for a different

station with the same programming, even during

preset recall.

1 Touch “AUTO PI” in the INITIAL menu.

Touching “AUTO PI” switches between “ON”

and “OFF”.

Switching the auxiliary setting

It is possible to use auxiliary equipment with nav-

igation unit. Activate the auxiliary setting when

using auxiliary equipment connected to naviga-

tion unit.

1 Touch “AUX” in the INITIAL menu.

Touching “AUX” switches between “ON” and

“OFF”.

Selecting the illumination col-

our

This unit is equipped with two illumination col-

ours, green and red. You can select the desired

illumination colour.

1 Touch “ILLUMI” in the INITIAL menu.

Touching “ILLUMI” switches between

“GREEN” (green) and “RED” (red).

Setting the rear output and sub-

woofer controller

This unit’s rear output (rear speaker leads output

and RCA rear output) can be used for full-range

speaker (REAR SP FULL) or subwoofer (REAR

SP SUB. W) connection. If you switch the rear

output setting to the REAR SP SUB. W, you can

connect a rear speaker lead directly to a sub-

woofer without using an auxiliary amp.

Initially, navigation unit is set for rear full-range

speaker connection (REAR SP FULL). When

rear output is connected to full range speakers

(when REAR SP FULL is selected), you can con-

nect the RCA subwoofer output to a subwoofer.

In this case, you can select whether to use the

subwoofer controller’s (low pass filter, phase)

built-in PREOUT SUB. W or the auxiliary

PREOUT FULL.

1 Touch “REAR SP” in the INITIAL menu.

2 Touch “REAR SP” to switch the rear out-

put setting.

When no subwoofer is connected to the rear

output, select FULL.

When a subwoofer is connected to the rear

output, select SUB. W.

❒ When the rear output setting is SUB. W,

you cannot change the subwoofer control-

ler.

3 Touch “PREOUT” to switch the sub-

woofer output or non fading output.

❒ Even if you change this setting, there is no

output unless you turn “NON FADING” or

“SUB WOOFER” in the AUDIO menu

“ON”.

➲ Using non fading output ➞ Page 89

➲ Using subwoofer output ➞ Page 89

❒ If you change the subwoofer controller

(REAR SP), the subwoofer output (SUB

WOOFER) and non fading output (NON

FADING) in the AUDIO menu return to

the factory settings.

❒ Both rear speaker leads output and RCA

rear output are switched simultaneously in

this setting.

Switching the sound muting/

attenuation

Sound from this system is muted, attenuated or

mixed automatically in the following cases:

• When a call is made or received using a cellu-

lar telephone connected to navigation unit.

• When the voice guidance is output.

1 Touch “TEL/GUIDE” in the INITIAL

menu.

Each touch of the “TEL/GUIDE” changes the

settings as follows:

• MUTE — Muting

• ATT — Attenuation

• NORMAL — Volume does not change

❒ The sound is turned off, no audio adjust-

ment is possible.

❒ When a phone connection is made,

MUTE or ATT is indicated.

Initial Settings

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 136 137

Commentaires sur ces manuels

Pas de commentaire