Pioneer AVIC Z3 Guide d'installation télécharger pdf (Page 30)

After Installing this

Navigation System

1 Reconnecting the battery.

First, double-check that all connections are

correct and that this product is installed cor-

rectly. Reassemble all vehicle components

that you previously removed. Then reconnect

the negative (–) cable to the negative (–) term-

inal of the battery.

2 Start the engine.

3 Press RESET button.

Press RESET button on the navigation unit

using a pointed object such as the tip of a

pen.

4 Enter the following settings:

1 Make any necessary installation angle ad-

justments. (Refer to the operation manual.)

2 Change [Regional Settings] if necessary.

(Refer to the operation manual.)

3 Drive until the initialized sensors start oper-

ating normally.

Set the navigation system as explained in the

operation manual or hardware manual.

Note

After installing this navigation system, be sure to

check at a safe place that the vehicle is perform-

ing normally.

After Installation

Section

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 58 59

Pas de commentaire

Pioneer AVIC Z3 Guide d'installation Page 30