Pioneer VSX-D512 Manuel d'utilisateur télécharger pdf (Page 36)

Using the tuner07

36

En

Listening to the radio

The following steps show you how to tune to FM

and AM radio broadcasts using the automatic

(search) and manual (step) tuning functions.

Once you are tuned to a station you can

memorize the frequency for recall later—see

Saving station presets on the next page for more

on how to do this.

ENTER

TUNING

BAND MPX

RF ATT

TUNER

RECEI-

VER

1 Press the TUNER button on the remote

control to select the tuner.

You can also use the MULTI JOG/INPUT

SELECTOR dial on the front panel.

2 Use the BAND button to change the

band (FM or AM), if necessary.

Each press switches the band between FM and

AM.

3 Tune to a station.

There are three ways to do this:

Automatic tuning

To search for stations in the currently

selected band, press and hold TUNING +/

– for about a second. The receiver will start

searching for the next station, stopping

when it has found one. Repeat to search

for other stations.

Manual tuning

To change the frequency one step at a

time, press TUNING +/–.

High speed tuning

Press and hold TUNING +/– for high speed

tuning. Release the button at the

frequency you want.

Improving FM stereo sound

If the TUNED or STEREO indicators don't light

when tuning to an FM station because the

signal is weak, press the MPX button to switch

the receiver into mono reception mode. This

should improve the sound quality and allow you

to enjoy the broadcast.

Using the RF attenuator

If the radio signal is too strong and/or the

sound is distorting press RECEIVER (remote),

then press the RF ATT button to attenuate

(lower) the radio signal input and reduce the

distortion (for FMstations only).

XRE3068A.En.36.43 03.2.3, 11:13 AM36

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 95 96

Commentaires sur ces manuels

Pas de commentaire