Pioneer VSX-D512 Manuel d'utilisateur Page 32
- Page / 96
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Setting up the receiver06
32
En
The setting display is automatically exited
after 20 seconds of inactivity.
Speaker setting
• Default setting: S (all speakers)
You must let the receiver know how many
speakers you have, and how big they are. The
size you choose (large or small) determines
how much bass is sent from the receiver to the
speakers.
In the display, F, C, and S refer to front, center,
and surround speakers respectively. Speaker
size is denoted as L for large speakers, S for
small speakers, and (asterisk) if no speaker is
connected.
• Cycle through the available choices
using ’ or ‘ and choose a configuration
that matches your speaker setup.
One of the following configurations should
match your setup:
FL-CL-SL
FL-CL-SS
FL-CL-S
FL-CS-SL
FL-CS-SS
FS-C -SS
FS-CS-S
FS-CS-SS
FL-C -SS
FL-C -SL
FL-CS-S
• If the cone size (diameter) of the speaker is
larger than 15 cm, set the speaker size to L.
• If you’re not using a subwoofer, we
recommend setting the front speakers to L.
Subwoofer setting
• Default setting: ON
You can choose whether the subwoofer is used
or not. Use the plus (PLS) setting for extra bass.
• Use ’ or ‘ to select subwoofer ON, PLS
or OFF.
• If you chose the small front speaker
setting, SUBWF ON is automatically set and
locked.
• When you select the plus setting, you will
get the bass sounds from the subwoofer even
if the front speakers are set to L.
Crossover frequency setting
• Default setting: 100 Hz
Crossover frequency is the point where the
receiver divides the high and low sounds (the
frequencies) between the speakers. Since most
smaller speakers can’t handle deep bass tones,
you can send these sounds to the subwoofer (or
if you don’t have a subwoofer, the large (L)
speakers in your system) instead of the
speakers set to small (S) in your setup. Choose
the point at which you want the frequency
routed to the subwoofer (or L speakers).
We recommend setting this to 200 Hz if your S
speakers are smaller bookshelf-type speakers.
• Use ’ or ‘ to specify the crossover
frequency for your small speakers (100 Hz,
150 Hz or 200 Hz).
XRE3068A.En.31.35 03.2.3, 11:11 AM32
- VSX-D512 1
- Installing the Receiver 3
- Contents 4
- 7 Using the tuner 5
- 8 Making recordings 5
- 9 Additional information 5
- Dry cell batteries 6
- (AA size IEC R6) × 2 6
- Introduction to home theater 7
- Listening to Surround Sound 8
- 5 minute guide02 10
- 5 minute guide 11
- Using the Quick Setup 11
- Audio/Video cords 12
- Connecting up 13
- Connecting digital components 13
- Connecting audio components 13
- Connecting video components 14
- Connecting up03 14
- FM wire antenna 15
- Connecting antennas 15
- To improve FM reception 16
- To improve AM reception 16
- Antenna snap connectors 16
- Speaker terminals 17
- Connecting the speakers 17
- Hints on speaker placement 18
- POWER-CORD CAUTION 19
- Controls and displays04 20
- Front Panel 20
- Controls and displays 21
- Remote Control 24
- Stereo/Direct 26
- Standard modes 26
- Advanced Surround modes 26
- Playing sources 27
- Choosing the input signal 27
- Using Stereo/Direct 27
- Virtual SB 28
- 5-Stereo 28
- Expanded 28
- Using the tone controls 29
- Playing other sources 29
- Playing sources05 30
- Selecting the multi-channel 30
- Setting up the receiver 31
- Choosing your receiver setup 31
- Speaker setting 32
- Subwoofer setting 32
- Crossover frequency setting 32
- LFE attenuator setting 33
- Setting up the receiver06 34
- Coaxial digital 1: 34
- Coaxial digital 2: 34
- Optical digital input setting 35
- Improving FM stereo sound 36
- Using the RF attenuator 36
- A - 99.50 37
- Using the tuner07 38
- Naming station presets 38
- Listening to station presets 38
- Using the tuner 39
- An introduction to RDS 39
- Using the RDS display 40
- Searching for RDS programs 40
- Using EON 41
- Monitoring your recording 43
- Additional information09 44
- Troubleshooting 44
- Additional information 45
- Amplifier Section 46
- Video Section 46
- FM Tuner Section 46
- AM Tuner Section 46
- Miscellaneous 47
- IInstallazione del ricevitore 49
- 9 Altre informazioni 51
- Attenzione 52
- Guida in 5 minuti 53
- Guida in 5 minuti02 54
- Cavi audio/video 58
- Collegamento 59
- Collegamento03 60
- Antenna FM a filo 61
- Collegamento delle antenne 61
- Utilizzo di antenne esterne 62
- Antenna AM a telaio 62
- Terminali dei diffusori 63
- Collegamento dei diffusori 63
- Comandi e display04 66
- Pannello anteriore 66
- Comandi e display 67
- Telecomando 70
- Stereo/Diretto 72
- Modi Standard 72
- Modi Advanced Surround 72
- Riproduzione delle fonti 73
- Scelta del segnale di entrata 73
- Utilizzo dei comandi dei toni 75
- Riproduzione di altre fonti 75
- Riproduzione delle fonti05 76
- Selezione delle entrate 76
- Configurazione del ricevitore 77
- Scelta di configurazione per 77
- Impostazione dei diffusori 78
- Impostazione del subwoofer 78
- Impostazione dual mono 80
- Impostazione dell’entrata 80
- Utilizzo dell’attenuatore RF 82
- Utilizzo del sintonizzatore07 84
- Per assegnare un nome alle 84
- Per ascoltare le stazioni 84
- Utilizzo del sintonizzatore 85
- Utilizzo del display RDS 86
- Ricerca di programmi RDS 86
- Informazioni di base sull’EON 87
- Utilizzo del sistema EON 87
- EON da tutte le stazioni 88
- Monitoraggio di una 89
- Altri informazioni 90
- Soluzione dei problemi 90
- Sezione amplificatore 92
- Sezione video 92
- Sezione sintonizzatore FM 92
- Sezione sintonizzatore AM 92
- Pulizia dell’apparecchio 93
- PIONEER CORPORATION 96
Produits connexes et manuels pour Récepteurs AV Pioneer VSX-D512
Récepteurs AV Pioneer DJM400 Fiche technique
(76 pages)
(76 pages)
(2 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.774 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels