Pioneer PDK-50HW3 Manuel d'utilisateur télécharger pdf (Page 38)

4. Installing and Using Software

4.5 Using Driver and Service Mode

4.5.1 Service Mode display

Press the Service Mode button in the “Test Mode” screen to open the “Service Information” screen.

a) Screen items

This screen shows service information and DIP switch information for handwriting device.

[Displayed service information]

LED/Sens Area: Test board number (See figure below.)

Point: Test address number

Status: Assessment Normal = OK

Malfunction = E01, ALL, Check

[Displayed DIP SW information]

Handwriting device DIP switch information (Binary expression)

[SelfTest button]

Perform self test. The button cannot be pressed using the touch screen. Click the button using the mouse without

touching the screen. Do not touch the screen until screen changes on the next item b) appears.

Notes:

Perform self test under the following conditions.

¶ Make sure that the numbers in the second and fourth boxes from the left in the DIP SW Information are both “0”. Locked low scan

mode and ultra low scan mode do not provide a correct assessment.

¶ Perform the test with the scan device firmly installed in the plasma display as a correct assessment will not be obtained unless the

scan device is correctly installed.

b) Status displayed after pressing SelfTest button

1. When LED and Sens are normal

The detailed list (in the lower half of screen) shows no data.

FRONT SIDE VIEW

Sens boards

Sens

boards

LED boards

LED

boards

Relationship between Area and board location is

shown below.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Pas de commentaire

Pioneer PDK-50HW3 Manuel d'utilisateur Page 38