Pioneer PDP-507XD Manuel d'utilisateur télécharger pdf (Page 19)

Preparation

English

Attaching speed clamps to the main unit

Attach the speed clamps using the 3 holes (42 inches: 2 holes)

marked with below, depending on your routing system.

for PDP-507XD

for PDP-427XD

Attaching and removing speed clamps

Insert [1] into an appropriate hole on the rear of the Plasma

Television and snap [2] into the back of [1] to lock the clamp.

Speed clamps are designed to be difficult to undo once in

place. Please attach them carefully.

Use pliers to twist the clamp 90º, pulling outward. The clamp

may deteriorate over time and become damaged if removed.

Be careful not to subject any connecting cables to strain.

NOTE

• Use the supplied speed clamps as necessary.

Connecting to an antenna

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used

for a coaxial cable.

Antenna cable (commercially available)

OUT

Standard DIN45325 plug (IEC169-2)

75-ohm coaxial cable (round cable)

(commercially available)

• For viewing both analogue and digital broadcasts, connect the

antenna cable to the ANT OUT terminal (antenna through out) and

ANT (analogue input) terminal.

• If “Aerial Power” setting is enabled, use an indoor antenna with signal

amplifier, 5V 30mA.

• For viewing analogue broadcasts only, connect

the 75-ohm coaxial cable (commercially

available) to ANT (analogue input) terminal.

If your outdoor antenna uses a 75-ohm coaxial cable with a standard

DIN45325 plug (IEC169-2), plug it into the antenna terminal at the rear of

the Plasma Television.

PDP507XDE.book Page 19 Friday, June 2, 2006 3:07 PM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 217 218

Pas de commentaire

Pioneer PDP-507XD Manuel d'utilisateur Page 19