Pioneer AXM-P90RS Manuel d'utilisateur télécharger pdf (Page 26)

Important

! This unit can not be installed in a vehicle that

does not have an ACC (accessory) position on

the ignition switch.

ACC position No ACC position

! Use of this unit in conditions other than the

following could result in fire or malfunction.

— Vehicles with a 12-volt batter y and negative

grounding.

! To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

— Disconnect the negative terminal of the

battery before installation.

— Secure the wiring with cable clamps or ad-

hesive tape. To protect the wiring, wrap ad-

hesive tape around them where they lie

against metal parts.

— Place all cables away from moving parts,

such as gear shift and seat rails.

— Place all cables away from hot places,

such as near the heater outlet.

— Do not pass the battery cable (translucent

with yellow stripe) through a hole into the

engine compartment to connect to a bat-

tery.

— Cover any disconnected cable connectors

with insulating tape.

— Do not shorten any cables.

— Never cut the insulation of the power cable

of this unit in order to share the power

with other devices. Current capacity of the

cable is limited.

— Use a fuse of the rating prescribed.

! Refer to the owner’s manual for details on

connecting the power amp and other units,

then make connections correctly.

! IP-BUS connectors are color-coded. Be sure

to connect connectors of the same color.

Cord function may differ according to the pro-

duct, even if cord color is the same. When con-

necting this system, be sure to check all

manuals and connect cords correctly.

Connections

Section

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 40 41

Commentaires sur ces manuels

Pas de commentaire

Pioneer AXM-P90RS Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Multimédia automobile Pioneer AXM-P90RS