Pioneer AVH-P3400DVD Manuel d'utilisateur télécharger pdf (Page 52)

Note

When you select a cross-over frequency, you are

setting the cross-over frequency for the subwoo-

fer’s LPF (low-pass filter) and the Small speak-

er’s HPF (high-pass filter). The cross-over

frequency setting has no effect if the subwoofer

is set to Off and other speakers are set to Large

or Off.

Adjusting the speaker output

levels using a test tone

You can easily get the right overall balance

among the speakers with this function.

1 Display the DSP function menu.

Refer to Introduction of menu operations on

page 43.

2 Touch Test Tone.

3 Touch Start to start test tone output.

The test tone is emitted from each speaker in

the following sequence at intervals of about

two seconds. The current settings for the

speaker emitting the test tone will be shown

on the display.

Front-L (left front speaker)—Center (center

speaker)—Front-R (right front speaker)—

Rear-R (right rear speaker)—Rear-L (left rear

speaker)—Subwoofer (subwoofer)

Check each speaker output level. If no adjust-

ments are needed, perform step 5 to stop the

test tone.

# The settings for speakers with the size set to

Off will not be displayed. (Refer to Setting the

speaker setting on page 50.)

4 Touch c or d to adjust the speaker out-

put level.

Range: +10 to –10

# The test tone will be emitted from the next

speaker after about two seconds after the last op-

eration.

5 Touch Stop to end test tone output.

Notes

! If necessar y, select speakers and adjust their

‘absolute’ output levels. (Refer to Adjusting

the speaker output levels on the previous

page.)

! You will get the same results whether you ad-

just the speaker output levels with this mode

or with Speaker Level.

Using time alignment

The distance between the listening position

and each speaker can be adjusted with this

function.

1 Display the DSP function menu.

Refer to Introduction of menu operations on

page 43.

2 Touch Time Alignment.

3 Touch any of the following touch panel

keys to select the time alignment.

! Initial – Initial time alignment (factory set-

ting)

! Auto TA – Time alignment created by auto

TA and EQ. (Refer to Auto TA and EQ (auto-

time alignment and auto-equalizing) on

page 54.)

! Custom – Adjusted time alignment that

you can create

! Adjustment – Enables adjusting the time

alignment as desired

! Off – Turns Time Alignment off

# You cannot select Auto TA if auto TA and EQ

have not been carried out.

# Adjustment can only be selected when either

Front-L or Front-R is selected in Position.

Adjusting time alignment

The distance between the selected position

and each speaker can be adjusted.

! The adjusted time alignment is stored in

Custom.

En

52

Section

12

Menu operations

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 111 112

Commentaires sur ces manuels

Pas de commentaire