Pioneer F40 Manuel d'opérations télécharger pdf (Page 168)

Using sonic centre control

Sound that is suited for the listening position

can easily be created with this function.

1 Display the “AV Sound Settings”

screen.

= For details, refer to Displaying the screen for

AV sound settings on page 162.

2 Touch [Sonic Center Control].

3 Touch [c]or[d] to select a listening po-

sition.

p The larger the value of the range: “Left7” to

“Right7” setting, the greater the delay of

the speaker output.

p When “Left” is set, the left speaker output

is delayed. When “Right” is set, the right

speaker output is delayed.

Adjusting loudness

Loudness compensates for deficiencies in the

low- and high-sound ranges at low volume.

1 Display the “AV Sound Settings”

screen.

= For details, refer to Displaying the screen for

AV sound settings on page 162.

2 Touch [Loudness].

Each time you touch [Loudness], the level is

selected in the following order:

Off — Low — Mid — High

Using subwoofer output

The navigation system is equipped with a sub-

woofer output mechanism, which can be

turned on or off.

p This function is not available when “Sub

Woofer” is “Off”.

p With the AVIC-F840BT, this setting is not

available when “Rear SP” is set to “Full”

and “Preout” is set to “Rear”.

= For details, refer to Setting the rear out-

put on page 160.

= For details, refer to Switching the preout

setting on page 160.

1 Display the “AV Sound Settings”

screen.

= For details, refer to Displaying the screen for

AV sound settings on page 162.

2 Touch [Sub Woofer].

3 Touch [On].

The subwoofer output is turned on.

# If you touch [Off], the subwoofer output is

turned off.

4 Touch [Reverse] or [Normal] to select

the phase of subwoofer output.

5 Touch [+] or [–] next to “Level” to adjust

the output level.

“+6” to “–24” is displayed as the level is in-

creased or decreased.

6 Touch [c]or[d] next to

“Frequency(Hz)” to select cut-off fre-

quency.

Each time you touch [c]or[d], cut-off fre-

quencies are selected in the following order:

50Hz — 63Hz — 80Hz — 100Hz — 125Hz

Only frequencies lower than those in the se-

lected range are output from the subwoofer.

Using the high pass filter

When you cut lower sounds from the subwoo-

fer output frequency, activate HPF (high pass

filter). Only frequencies higher than those in

the selected range are output from the front or

rear speakers.

1 Display the “AV Sound Settings”

screen.

= For details, refer to Displaying the screen for

AV sound settings on page 162.

Engb

168

Chapter

27

Customising preferences

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 219 220

Commentaires sur ces manuels

Pas de commentaire