Pioneer VSX-517-S/-K Manuel d'utilisateur télécharger pdf (Page 60)

Additional information11

60

En

Resetting the main unit

Use this procedure to reset all the receiver’s

settings to the factory default. Use the front

panel controls to do this.

1 Switch the receiver into standby.

2 While holding down the TONE button,

press and hold the



STANDBY/ON button for

about three seconds.

3 When you see RESET? appear in the

display, press the

ENTER

button.

OK?

shows in the display.

4 Press

SETUP

to confirm.

OK

appears in the display to indicate that the

receiver has been reset to the factory default

settings.

Switching the speaker impedance

We recommend using speakers of 8

Ω

with this

system, but it is possible to switch the imped-

ance setting if you plan to use speakers with a

6

Ω

impedance rating.

• With the receiver in standby, press



STANDBY/ON

while holding down the

QUICK SETUP

(VSX-517)

/ SPEAKERS

(VSX-817)

button.

Each time you do this, you switch between the

impedance settings:

•

SP 6 OHM

– Use this setting if your

speakers are rated at 6

Ω

.

•

SP 8 OHM

– Use this setting if your

speakers are rated at 8

Ω

or more.

Power cord caution

Handle the power cord by the plug. Do not pull

out the plug by tugging the cord and never

touch the power cord when your hands are wet

as this could cause a short circuit or an electric

shock. Do not place the unit, a piece of

furniture, etc., on the power cord, or pinch the

cord. Never make a knot in the cord or tie it

with other cords. The power cords should be

routed such that they are not likely to be

stepped on. A damaged power cord can cause

a fire or give you an electrical shock. Check the

power cord once in a while. When you find it

damaged, ask your nearest Pioneer authorized

service center or your dealer for a replacement.

VSX517_817.fm 60 ページ２００７年２月２２日　木曜日　午後８時１１分

1 2 ... 55 56 57 58 59 60 61 62 63

Commentaires sur ces manuels

Pas de commentaire